Solved Windows doesn't obtain IP add automatically.

paulsep August 28, 2011 at 12:00:26

What kind of DHCP server are you running, any kind of server, router or modem to optain ip from your ISP? You are expecting our help, we are expecting your response !!!

yes its DSL modem. I think there is any service in "windows services" that is disabled. but I dont know which service. any way waiting for ur suggestion, thanx.

paulsep August 28, 2011 at 14:37:48

✔ Best Answer

The service for DHCP is DHCP client. What does an ipconfig /all show? Is DHCP enabled? You are expecting our help, we are expecting your response !!!

let me check. it will take some time.

hey I have checked the service DHCP. It is automatic but stopped. When I start the service. It doesn't. It shows error. Could not start the DHCP Client service on Local Computer. Error 1068: The Dependency service or group failed to start.

paulsep September 18, 2011 at 13:21:31

You may try the following: 1. open an administrator command prompt (right click command prompt clicking run as admin 2. type netsh winsock reset in the command prompt and 3. reboot You are expecting our help, we are expecting your response !!!

dear brother, when I try to run command prompt as administrator. It doesn't. Error shows. Unable to log on: Logon failure: user account restriction. Possible reasons are blank passwords not allowed. logon hour restrictions, or a policy restriction has been enforced. http://www.4shared.com/photo/dx4gwD... Please help.

wanderer September 20, 2011 at 12:37:12

this pc part of a domain? can you logon locally as administrator? Answers are only as good as the information you provide. How to properly post a question: Sorry no tech support via PM's

not a part of any network. domain or any other. Let me check it about the user. windows starts without any authentication. i.e user and password. later. thanks

As I said before it is connected with DSL modem/router only.

paulsep September 21, 2011 at 12:44:40

You have to figure out, why DHCP service on your computer is not starting. Or, if you know the ip of your router, you can set the ip address of your computer manually. E.g.: If the routers ip address is 192.168.1.1, and has a default subnet mask of 255.255.255.0, you can configure your computers ip address as follows: ip address: 192.168.1.2 subnet mask: 255.255.255.0 default gateway: 192.168.1.1 (your routers address) DNS server: 192.168.1.1 (your routers address) You are expecting our help, we are expecting your response !!!

Yes dear I have set these config manually a long time ago and working fine. no issue. But I want this to detect automatically via DHCP. thats why I am asking. I want to troubleshoot this issue. Please help. Thanks.

paulsep September 22, 2011 at 18:03:46

Therefore, you have to check the errors in event viewer to figure out, which service or dependency causes the DHCP client not to start. You are expecting our help, we are expecting your response !!!