monitor in power save mode activate using pc

December 15, 2009 at 20:38:52
Specs: Windows XP
After unplugging monitor cable from computer (while on) (may have been my mistake) LCD monitor is blank and orange light in standby. Pushing any button says "In Power Save Mode- press any key or move mouse" Nothing happens..screen black...how to get screen back on PLEASE HELP !!! Did something go wrong? Hope Not...PLEASE REPLY Thank You


See More: monitor in power save mode activate using pc

Report •


#1
December 15, 2009 at 20:47:46
Have you disconnected the monitor's electrical plug? Have you turned the computer off and unplugged the monitor's cable and then installed the monitor's cable with the computer shut down? You might have caused an electrical surge or short when you removed the monitor's cable with the computer turned on. You might try resetting the bios using the the reset jumper or by removing the cmos battery for several minutes.

Report •

#2
December 18, 2009 at 04:08:32
yes i removed the CMOS battery for a few minutes then put it back and when i reconnected my computer, everything was ok.
thank you so much.

Report •

Related Solutions


Ask Question