Solved local area connection and critical error driv

August 11, 2011 at 23:14:06
Specs: Windows XP sp3
I have my local area connections all messed up. I'm connected, firewalled Hi speed broadband.. satelite. settings are for automatic it's the box that says "this connection uses" I dont know what all I'm supose to check on the list. I'm now getting a systems reading that says ( pci Bus Driver Kernal driver - started-yes. boot running. Status OK Error Control CRITICAL. excepts pause-NO/ excepts stop-YES. I'm asuming these are related problems. Any Hope for me?

See More: local area connection and critical error driv

Report •

August 13, 2011 at 09:35:45
✔ Best Answer
If after using HijackThis or cleaning out infections, connection is lost.
How to configure TCP/IP
To configure TCP/IP, follow these steps:
1. Click Start, click Control Panel, click Network and Internet Connections, and then click Network Connections.
2. Right-click the network connection that you want to configure, and then click Properties.
3. On the General tab (for a local area connection), or the Networking tab (for all other connections), click Internet Protocol (TCP/IP), and then click Properties.
4. If you want to obtain DNS server addresses from a DHCP server, click Obtain DNS server address automatically.
Right click Local Area Connection > Repair.

Report •

August 19, 2011 at 14:00:54
Thanks John, I tried all you sugested and to make a long story short., I went with the Open DNS program. Free version. It was among some of the articals you sent. and I'm sorry I didn't answer earlier but I wasn't sure about this till the lst few days.

Report •

August 19, 2011 at 16:08:29
Nice work turkeyrun41, thanks for letting us know.

Report •
Related Solutions

Ask Question