instalation problem

Toshiba Satellite c655-s5082 laptop
June 2, 2011 at 09:27:37
Specs: Windows XP, Pentium(R) Dual core
I open my new laptop (Toshiba) when i try to boot the system and instal windows XP this message was appear:
A problem has been detected and windows has been shut down to prevent damage to your computer.

If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps. Check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. Check you hard drive to make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption and then restart your computer.

Technical information:

what can I do in details please

See More: instalation problem

Report •

June 2, 2011 at 15:39:12
are you booting from an xp cd??


Report •

June 2, 2011 at 22:59:53
thanks for your interest larryf215 I boat it from XP CD
What the solution please?

Report •

June 3, 2011 at 00:08:49

Windows lost access to the system partition or boot volume during the startup process. Typical causes: Installing incorrect device drivers when installing or upgrading storage adapter hardware, or a virus.
* During setup (Sysprep issue) {KB 303786} Win XP
* When You Press F6 to Load Drivers During Unattended Win XP Setup {KB 307099} Win XP
* When you restart your Win XP-based computer {KB 316401} Win XP (after replacing motherboard)
* When you start your computer from a WinPE CD-ROM or from a Server 2003 CD-ROM using a USB CD-ROM device {KB 839210} Win XP, Win Server 2003 (patch available)
* Limited OEM driver support is available with F6 during Win XP & Server 2003 setup {KB 314859} Win XP, Win Server 2003
* Error message When Starting Windows Vista After Changing SATA Mode of Boot Drive: STOP 0x0000007B INACCESSABLE_BOOT_DEVICE {KB 922976} Vista

I suggest you search the Microsoft site(s) for more details.

Report •

Related Solutions

June 3, 2011 at 07:56:21
"A problem has been detected and windows has been shut down to prevent damage to your computer."

If you are seeing that error message, then you are not booting to the CD, you are booting to the hard drive with a corrupt operating system on it. You need to go into the BIOS and change the boot order so it boots from the CD first.

Report •

Ask Question