how to fix or repair e machine T3516 problem

December 6, 2010 at 17:48:02
Specs: Windows xp
push button, power light on, monitor black, indicator light not blinking. repaired(shop) on 02/2010, indicator light switch(wire) broken, could that be problem again?

See More: how to fix or repair e machine T3516 problem

December 6, 2010 at 18:24:32
"repaired(shop) on 02/2010"
what did they say the problem was back in February.


Report •

December 6, 2010 at 20:20:55
emachines desktop computers usually use BESTEC power supplies - they have a reputation of malfunctioning or failing completely a lot more often than average, and when they do that, they are a lot more likely than average to damage something else, often the mboard.
BESTEC power supplies malfunctioning or failing is probably the most frequent reason an emachines desktop computer will no longer boot properly, and when you replace it you may find the computer still won`t boot, probably because the mboard has been damaged.

Failing power supplies are common and can cause your symptoms.
Check your PS.
They often partially work, fans and hard drives may spin, leds may come on, yet you may get no video and the mboard will not boot all the way.
See response 4 in this:

If you can borrow a known good PS from another desktop computer, try connecting that before buying a new PS.

Standard (PS/2) power supply size - 86mm high, 150mm wide, 140mm deep, or 3 3/8" h x 5 7/8" w x 5 1/2" d , or very close to that, though the depth can be more or less for some PSs.

Don't buy another BESTEC PS.
Don't buy an el-cheapo PS.
See response 3 in this:

Your power supply must have at least the minimum capacity required to support a system with the graphics card you are using installed, or the max graphics card you might install in the future.
(Onboard video - video built into the mboard - IS NOT A CARD ! )
If that info is not in the ad for the video card, you can go to the video card maker's web site and look up the specs for the model - often under system requirements - the minimum PS wattage, and, more important, the minimum amperage the PS must supply at 12v is stated. If you don't find that, any card with the same video chipset including any letters after the model number has very similar minimum PS requirements. Some power supplies have two or more +12v ratings - in that case, add those ratings to determine the total +12v current capacity.

If you're a gamer...
In most if not all cases, the max capacity rating of the PS is an intermittent rating. It's recommended that you do not load your PS to any more that 80% of that rating if you are going to be using something that puts a constant load on it, such as playing a recent game for hours on end. In that case, you multiply the min capacity stated for the system with the particular video chipset on the card by 1.25 to find the min. capacity of the PS you should get.

Report •
Related Solutions

Ask Question