Solved TCP client software

July 8, 2011 at 06:13:49
Specs: Windows Vista
Hi All,
Does anyone know a tcp client software other than telnet and can read data in other formats than ASCII ? the problem i am facing with telnet is that it only reads ASCII format.
Any help would be appreciated.

See More: TCP client software

Report •

✔ Best Answer
July 11, 2011 at 14:19:00
Might re-read the PuTTY documentation again

"In order to make a debugging connection to a service of this type, you simply select the fourth protocol name, ‘Raw’, from the ‘Protocol’ buttons in the ‘Session’ configuration panel. (See section 4.1.1.) You can then enter a host name and a port number, and make the connection. "

http://the.earth.li/~sgtatham/putty...

Answers are only as good as the information you provide.
How to properly post a question:
Sorry no tech support via PM's



#1
July 8, 2011 at 06:46:54
what OS's are in use on both sides?

Report •

#2
July 8, 2011 at 06:54:17
You would start will telling us what these other formats you need to read are.

Answers are only as good as the information you provide.
How to properly post a question:
Sorry no tech support via PM's


Report •

#3
July 8, 2011 at 07:21:14
thanks for your replies. Well, I am receiving raw data from an ADC in a microcontroller. so the data isn't sent in ASCII format, i can change the data to ASCII format but that will be a waste of energy since i will be sending extra bytes. Microsoft windows is used on the pc

Report •

Related Solutions

#4
July 8, 2011 at 12:36:48
have you tried PuTTY?

Answers are only as good as the information you provide.
How to properly post a question:
Sorry no tech support via PM's


Report •

#5
July 11, 2011 at 14:02:25
yes I did , can only read ASCII as well... any other ideas ?

Report •

#6
July 11, 2011 at 14:19:00
✔ Best Answer
Might re-read the PuTTY documentation again

"In order to make a debugging connection to a service of this type, you simply select the fourth protocol name, ‘Raw’, from the ‘Protocol’ buttons in the ‘Session’ configuration panel. (See section 4.1.1.) You can then enter a host name and a port number, and make the connection. "

http://the.earth.li/~sgtatham/putty...

Answers are only as good as the information you provide.
How to properly post a question:
Sorry no tech support via PM's


Report •

#7
July 11, 2011 at 15:27:34
thanks a lot for the help :)

Report •

Ask Question