Click here for important information about

removing ddwrt fw from my dlink dir825

August 27, 2010 at 08:26:54
Specs: dd-wrt
How do i remove the dd-wrt firmware on my dlink dir825

See More: removing ddwrt fw from my dlink dir825

August 27, 2010 at 10:43:50
Download the latest firmware for your DLink router and save it to your harddisk.

Then do a hard reset on the router, means press the reset button for 30 seconds.
Next flash the D-Link firmware by using the routers GUI.
Make sure to not interrupt the flashing process.
When you get the message, that flashing has completed, let the router alone for another 10 minutes, then do another hard reset.

This should work for you.

The original poster should always write the last response !!!
Let us know, if the problem is solved !!!

Report •

August 27, 2010 at 11:04:04
i tried that but the gui says upgrade failed

Report •

September 4, 2010 at 20:17:31
Try using the Emergency interface:

* Unplug the router's power cord and wait 20 seconds.
* Get a pin, push the RESET button and KEEP IT PRESSED.
* Connect the power cord back (while still keeping the reset button pressed)
* Keep the reset button pressed for an additional 5 seconds after connecting power cord and then release. At this point you should see the power button blinking orange.
* Connect over a WIRED connection to the router and set your network adapter IP MANUALLY to
* Open in a browser. You should see a white page with a Browse and Upload button.

Report •

Related Solutions

September 5, 2010 at 08:12:13
i tried that and it actually worked!! but the wireless card in the router somehow broke. well thx anyways

Report •

Ask Question