Function +B doesn't break in packet tracer

November 11, 2020 at 15:23:28
Specs: Windows 10
Function +B doesn't break in packet tracer. I'm using a T440p thinkpad with windows 10. No combination given has worked for me. Is there any other program i can use to test the break function?

See More: Function +B doesnt break in packet tracer


#1
November 11, 2020 at 15:40:07
You mean tracing IP packets?
Try WIRESHARK

Reply ↓  Report •

#2
November 12, 2020 at 07:15:35
I'm doing a lab for my CCNA in Cisco packet tracer. I have to turn off a router on the physical tab and then go to the CLI tab and interrupt the boot sequence so it goes to the Rommon prompt. I hope that clarifies the issue.

Thanks for your reply. I was able to figure it out.

message edited by keasbeydave


Reply ↓  Report •

#3
November 12, 2020 at 11:59:49
This question would be much better suited to a Cisco forum. There are lots of them online including forums dedicated to Cisco certifications and their exams.

It matters not how straight the gate,
How charged with punishments the scroll,
I am the master of my fate;
I am the captain of my soul.

***William Henley***


Reply ↓  Report •
Related Solutions


Ask Question