ipad fails talk respond communicate Dynalink

August 28, 2010 at 18:09:16
Specs: Windows XP
I purchased an iPad 3G with Wi-Fi, and also havw a Dynalink RTA1025W wireles router/modem,.the wireless between my laptop and the Dynalink works fine,When i turn my iPad on and wich I turned on the WiFi in th settings, it recognises the network being the Dyanalink name, but it keeps on askin me for the password and which every case it doesnt recognise it. any sugestions?

See More: ipad fails talk respond communicate Dynalink

Report •

#1
August 30, 2010 at 07:19:40
Hi,
Here is a list of possible solutions according to the problem you describe.

Check the wireless security option of your Wi-Fi router:

If you are using WEP security and have multiple WEP keys on your Wi-Fi router, try configuring your Wi-Fi router to use only a single WEP key in key index 1.

Consider using WPA or WPA2 instead. WPA and WPA2 encryption protocols are newer, more effective security options for wireless networks than the older WEP protocol.

Temporarily disable wireless encryption or security on the Wi-Fi router to rule out encryption issues.

Try resetting (turning off and then on again) your Wi-Fi router. Note: If your ISP also provides cable or phone service, check with them before attempting this step to avoid interruption of service.

Disable 40MHz in the 2.4GHz settings on the Wi-Fi router. Mac computers and iPad do not support this mode. Disabling it may reduce interference issues.

More information on this Apple webpage:
iPad: Troubleshooting Wi-Fi networks and connections
http://support.apple.com/kb/ts3237


Report •

#2
December 17, 2010 at 17:29:56
Hi Ozvass,
Just purchased an ipad and are having identical problems to you with my rta 1025w router.. Tried to solve by following jecs recommended solution but still cannot connect. Were you able to sort out the problem and get connected?
Would appreciate your advice.

Report •

#3
December 17, 2010 at 21:45:13
Hi ozman,
My problem lied wirh the Wireless Securty on my broadband modem/router. After phoning the manufacturers of the modem/router ie Dynalink they suggested to go into the sight of the Dynalink find the model of the modem/router or in your case if you have saved it, go into Wireless Security and put the name and model of your m/router then go to Wireless Security & select from the choice: WPA-PSK: Data Encryption:select TKIP.:: WPA Preshared Key (This is the most important step)
Format select ASCII chararacters then as a Pre-shared key select betweeen 8 and 63 then select apply. Hope this is of some help. Regards. ozvass

Report •
Related Solutions


Ask Question