Solved how to use the Belkin N300 on my Ipad

January 10, 2015 at 12:10:51
Specs: ipad
Although I can get the Belkin setup indicator on my Ipad, I am unable to setup the system the system up on my Ipad. Is anyone able to walk me through, what I thought was going to be a simple process. There is nothing on youtube re. Setup process.

See More: how to use the Belkin N300 on my Ipad

January 10, 2015 at 12:57:03
This is a wifi router and requires you to be able to connect the ipad to the router (via wifi).

Does your N300 have its wifi enabled at this time? If not then until the router has its wifi enabled there's no way you can connect the ipad to it... Typically to enable wifi on a router you need to connect to it via cat-5/ethernet from any computer that has an ethernet port... Then access the admin/management page; after-which go to wifi section and enable wifi. Also note the SSID and password for the wifi setup; you will need to know these in order to connect the ipad (to the Belkin in your case).

If you ipad is able to connect to the N300 via wifi then is it (the ipad) able to access the Belkin "homepage"/management page:

The above ip address is what you would type into your browser and thus access the admin/management page..; after-which you go the wifi setup area...

Some general discussion here (albeit the first one is Linux related - but likely valuable to read nonetheless as it suggest possible methods); and the other is useful how to from Apple-land?

message edited by trvlr

Report •

January 10, 2015 at 15:15:32
✔ Best Answer
I think all you are really asking is how to set up a Wifi (wireless) connection to your router. If so this is all you need to do:

The make and model of the router makes no difference.

Always pop back and let us know the outcome - thanks

message edited by Derek

Report •
Related Solutions

Ask Question