relabel Hard disk camcorder disks in Vista

Jvc Everio gz-mg730 30gb hard drive camc...
September 9, 2010 at 04:30:40
Specs: Windows Vista
I have a Hard disk video camera and until recently the labels were "F & G". The next time I was completing a film edit, the response "F\ not found" appeared and, on checking in "Computer" the disks were now labelled "G & H". On a new film this works OK but I am now unable to edit the films "work in progress".

See More: relabel Hard disk camcorder disks in Vista

Report •

September 9, 2010 at 05:25:20
Change, add, or remove a drive letter << click .............source
You can assign the letters C through Z to each drive on your computer. A and B are usually reserved for floppy disk drives, but if your computer does not have floppy disk drives, you can assign A and B to volumes.

(1) Open Computer Management by clicking the Start Orb button clicking Control Panel, clicking System and Maintenance, clicking Administrative Tools, and then double-clicking Computer Management. Administrator permission required If you are prompted for an administrator password or confirmation, type the password or provide confirmation.

(2) In the Navigation pane, click Disk Management.

(3) Right-click the partition or drive that you want to change, and then click Change Drive Letter and Paths.

(4) Do one of the following:
To assign a drive letter if one has not already been assigned, click Add, click the letter that you want to use, and then click OK.
To change a drive letter, click Change, click Assign the following drive letter, click the letter that you want to use, and then click OK.
To remove a drive letter, click Remove, and then click Yes to confirm that you want to remove it.
... Posting is provided "AS IS" with no warranties

Report •
Related Solutions

Ask Question