Solved I changed my CMOS BATTERY and now system not boot correctly

July 27, 2017 at 05:32:47
Specs: Windows 7, INTEL DC5100SFF
I changed my CMOS BATTERY and now system is not booting correctly one beep sound is came it will show the error as TIME IS NOT UPDATE DUE TO BATTERY FAILED .. PRESS F1 TO BOOT OPTION IS THERE IF I PRESS F1 SYSTEM IS BOOTING .


NEXT TIME WHEN IAM SWITCH ON MY SYSTEM SAME PROBLEM REPEATING.

WAHT CAN I DO FOR THIS ISSUE


See More: I changed my CMOS BATTERY and now system not boot correctly

Reply ↓  Report •

#1
July 27, 2017 at 06:09:24
✔ Best Answer
One possibility is that you put the battery in backwards. Depending
on the battery and the holder, that can be very easy to do.

Another possibility people have reported is that "new" batteries
can sometimes sit in the store or warehouse for so long that they
lose their oomph. If the package has an expiration date, you can
look at that. If you have a battery tester you can test it like any
button battery. If you have a voltage meter / multimeter you can
check the voltage. If it is much less than 3 volts, replace it. If it
is close to 3 volts, it is good.

-- Jeff, in Minneapolis


Reply ↓  Report •

#2
July 27, 2017 at 10:01:45
Bear in mind that "off load" - i.e. not connected to anything - a battery may appear to be OK; delivers more or less the correct volts when checked with a bolt meter. However "under load" - connected in cct. - it may then drop significantly as the battery is past its best (sell by date etc.).

Reply ↓  Report •

#3
July 27, 2017 at 10:08:38
The normal load in this case is so tiny that a voltmeter test
without any load should be very close. The clock circuit uses
very little current.

-- Jeff, in Minneapolis


Reply ↓  Report •

Related Solutions

#4
July 27, 2017 at 12:54:59
re' #3 - very true on this occasion.

Reply ↓  Report •

#5
July 27, 2017 at 18:43:44
What is the normal key to go into BIOS? F2, DEL, F10...?
F1 is usually to exit the POST and continue to boot.


Reply ↓  Report •

#6
July 27, 2017 at 18:58:16
You need to know what brand system in order to look up the correct key to access the BIOS set up and set the time, date, CPU, RAM, Primary Graphics, Boot drive, Boot order, etc. after replacing the battery with a new one.

You have to be a little bit crazy to keep you from going insane.


Reply ↓  Report •

#7
July 27, 2017 at 21:41:53

@Ramchan

Due To Changing The CMOS BATTERY, It is A Normal Event/Message.

- Turn-On System.
- Go/Switch to System BIOS setup (Press DEL or Defined - Function Key For Running The BIOS Setup Program)
- Set Correct DATE and TIME in BIOS.
- Save Changes and Exit.

Good Luck.


Reply ↓  Report •

#8
July 28, 2017 at 05:51:28
thanks ur answer is right

Reply ↓  Report •

Ask Question