Emachine..usb not recongized

December 6, 2010 at 10:55:32
Specs: Windows 7
SAY USB NOT RECONGIED BY HOOKING UP PRINTER WHY

See More: Emachine..usb not recongized

Report •

#1
December 6, 2010 at 11:23:43
Based on the detailed info about your system & printer, I would have to say - I don't know why it doesn't work.

Report •

#2
December 6, 2010 at 13:47:56
I DID EVERYTHING EMACHINE AND KODAK SAID TO DO AND STILL DONT WORK.........ARE THERE ANY COMPUTER WIZ OUT THE CAUSE I DONT KNOW MUCH ABOUT THIS COMPUTER ,,BUT IT WORKS ON OLD LAPTOP........HOPE SOME ONE CAN HELP ME...ITS DRIVING MER NUTS

Report •

#3
December 6, 2010 at 19:38:01
Device driver and other software installed?

Report •

Related Solutions

#4
December 6, 2010 at 21:39:29
Typing in all capitals in a post on the internet is considered to be the same as if you were shouting, and very rude !

"USB NOT RECONGIED"

You may need to plug the printer into a different USB port, and/or if you have a desktop computer, you may have an IRQ sharing problem you need to fix - a friend of mine's computer had the latter problem with a Kodak printer, and only the printer.

Troubleshooting USB device problems including for flash drives, external drives, memory cards.
See Response 1:
http://www.computing.net/answers/ha...

Check that out first.
......

Rarely, not all the ports on the back of a desktop case may be able to supply 500ma each.

If you have a desktop computer, Note that I answered a Topic on this site recently where a guy had an external drive, which does require the full 500ma, connected to a port on the back of a desktop case - it would not work properly when a webcam was in the port next to it, but it worked fine when the webcam was unplugged. Ports on the back of a desktop case often have two ports connected to the same USB controller module that are ports one above the other - you could try connecting the cable to one of those and leaving the other un-used.
......


Report •

Ask Question