BSOD On Start up after self system shutdown

Microsoft Windows xp tablet pc edition 2...
May 22, 2010 at 16:07:27
Specs: Windows XP Pro, Pentium M 1 Gb
Hello, I had restarted my computer after Unintentionally trying to overload the system. (You can't run Camstudio, VPC, VLC, & Record at the same time on a 1GHz Pentium M with 1 Gb. RAM.) After the restart, I loged into windows, and shortly after, it restarted it self using the shudows -r command. The message said "Warning!!! The system is going down!" in the message box. The error is

*** STOP: 0x00000c5 (0xE1A3D000, 0x00000002, 0x00000001, 0x8054BaEE)

Check to make sure any new hardware or software is properly installes.
If this is a new installation, ask your hardware or software manufacturer
For any windows updates you might need.

Run the driver verifier against any new (or suspect) drivers.
If that doesn’t reveal the corrupting driver, try enableing special pool.
Both of these features are intended to catch the corruption at an earlier
Point where the offending driver can be identified.

If you need to use Safe mode to remove or disable componets,
Restart your computer, press f8 to select Advanced Startup Options,
And then select safe mode.

If this is the first time you’ve seen this stop error screen,
Restart your computer. If this screen appears again, follow
These steps:

Check to make shure any new hardware of software is properly installed.
If this is a new installation, ask your hardware of software manufacturer
For any windows updates you might need.

If problems continue, disable or remove any newly installed hardware
Or software. Disable BIOS memory options such as caching or shadowing.
If you need to use safe mode to remove or disable componets, restart
Your computer, press f8 to select Safe mode to remove or disable componets, and then
Select safe mode.

Technical information:

*** STOP: 0x00000c5 (0xE1A3D000, 0x00000002, 0x00000001, 0x8054BaEE)


Thanks


See More: BSOD On Start up after self system shutdown

Report •


#1
May 22, 2010 at 20:25:54
How do you unintentionally "try" to overload a system? If you "try", that means it's intentional.

"Warning!!! The system is going down!"

I doubt that was the error message. And I think you're missing a zero in your stop code.

http://aumha.org/a/stop.htm

"shudows -r command" Do you mean SHUTDOWN? And how would you know the -r command was used unless YOU entered it? Something's not right with your explanation.


Report •

#2
May 23, 2010 at 15:18:05
I have used the command as a timer, to limit peoples time. We have gameing six computers, and, I put one of these into the startup file on each for 30 min, this was a free & easy way to limit their computer usage. I overloaded the system because I had pagefile disabled, & tried to record about
1.5 Gb. of movie onto 1 Gb. Ram. I read the error on the page you included, It said it was a corrupt driver error code. How would I know what driver is corrupt? I can boot into safemode, and safemode with networking, so, it eliminates the possibility of being network. I also ran windows memory diagnostic & memtest 86, but, I got no memory errors. If I need to reinstall windows, I can. I have the adapters for 2.5" IDE drives, so I can connect it to my desktop to recover the data.

Thanks


Report •

Related Solutions


Ask Question