Summary: I found that when I changed from a sempron 2800 to an athlon 64 3200, I noticed quite a jump in performance. Like the above post, it depends on what y...
Summary: Well my cpu will not boot up. I have gotten into windows on a few occassions. Cause it had told me my cmos battery was low. Now I have changed that, a...
Summary: I have just noticed that my CPU Fan is not working, I have 3 fans in and 3 fans out, I have a AMD 64-bit Athlon 3200 processor and I am not sure what ...
Summary: Hi, I recently damaged my CPU when following poor intructions for a heatsink. One of the resistors on it became damaged. I purchased an identical resi...
Summary: I am currently building a system with a ECS L7S7A2 mother board, AMD 2100+ 1.7 CPU and 1.5GB of memory. As I was going through ECS's manual they give ...
Summary: OK, Since we got this computer it has been overheating while playing the SIMS 2 and Joint Operations. About 15 minutes into each and it seems to freez...
Summary: yes i have replaced the ram it was only to test it.. now as soon as i press the power switch on my pc it just goes off. my psu is 500 watts im not qu...
Summary: I am still not sure how to do it. Okay let's try this: the first option in soft menu II is cpu op speed, the two most obvious choices would be 700(10...
Summary: I recently got a new pc and i have been checking the temperature regulary through bios everytime i have noticed it has been abit high running around 4...
Summary: The Duron should have a locked multiplier so you can't change it without modifying the cpu itself. I'm not sure how to do it on on a Duron so better r...
Summary: Yup youre right hehe, I had just looked and set both CPU and Memory to User Defined. Im at 200 x 11.5 and under memory its default settings something ...
Summary: well my temperature is at 40c max and 29c idle should a Chimney Air-Duct reduce the heat from the cpu? i'm not sure what to do about the heat i have a...
Summary: There are two ways. The easier is to raise the FSB and see how far it works with your system (take small steps !). The ram shouldn't be the problem bu...
Summary: I'm stressed too. Sounds like you've had similar problems. I'm almost at the point of buying a new motherboard (again). AMD Duron 650Mhz. 2 * 40GB IDE...
Summary: I've got an old AMD XP 2000 that I want to reuse to put into a shuttle pc. Two of the processor pads feel off and are intact and one split in half. I...
Summary: I have a ABIT KD7 motherboard with a AMD XP 2400+. The BIOS in it are Phoenix - AwardBIOS CMOS Setup Utility. RIght now i have my cpu opened with L1 ...
Summary: Alas! I found the jumper cable to my speaker, but I hear beeps! The beeps are continuous. I looked in my manual and it said DRAM. I know my CPU has it...
Summary: FAO: HOtSHot i dint change to promise as you instructed as i didnt think my files would get corrupted - and thankfully they didnt. Like i said i have ...
Summary: I don't think it's your psu; 300W should be enough juice. What you might want to check is if your video card is securely in its slot. My box used to...
Summary: forgot to put this in last message, yes i have heard of overclocking, but not sure how to do it. will it do any damage if done incorrectly?? ...
Summary: I just got my new motherboard, its an MSI K7N2 Delta nforce 2. This is also my first time building a computer from scratch and I'm not sure what to d...
Summary: Does the lead actually create a conductive path across the base of the pins or is there some other way????? im not sure how to do this??? Ive heard ...
Summary: My motherboard is a m7vig pro, and the program is called warpspeed overclock. I would like to overclock in the bios, but i'm a novice and not sure...
Summary: well i don't know if this is a tbred or not, cause i don't think it is. I picked it up in da store one day, cause it was on sale cheap. Tho i cannot...
Summary: you can't underclock durons. thier default speed is 100, so it has to be running at 1GHz. If you put it at 133, then it would try to run at 1333MHz, ...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
