Summary: Hi all folks OS:- RedHat7.3 =============== I am preparing to experiment the setup of software RAID 5 using only 3 hard discs. Any folk on this board...
Summary: Hi, I have bought a SuperMicro SuperServer with 4 SCSI drive armed with adaptech RAID 2010S. Now I've configured Hardware RAID-5. and Now I need to i...
Summary: Software RAID / accidentally raidhotadd to wrong md Issue summary: Had problems with 1 of a 3 drive software raid array. Harddrive is not physically ...
Summary: Hi, When i try to install RH 7.3 on my box with software raid the install freeze near the end. I have try without raid and with a 7.2, there is no pb....
Summary: Got a bit of the problem with the resources used by Red Hat 8.0's software Raid solution that makes the system crawl like a turtle with constant heart...
Summary: We had a DELL PowerEdge 2400 Server, shipped with two PIII 866MHz CPUs, 512M memory and two Seagate SCSI HDs. We want to build a FTP server, but SCSI...
Summary: i am trying to build a RAID system for just learning purpose .. i thought i would start with RAID 0 and later try RAID 1 and 5 .. i have 2 hdd's of sa...
Summary: As the subject says, I have a 3dfx Voodoo 3, XFree 4.0.1, kernel 2.4.5 and quake 3. Everything but quake was installed from slackware-current (7.2) w...
Summary: Hi ! I am using Red Hat 7.2, just recompile kernel 2.4.18 in one harddisk. Now after my newly compile kernel, I add in another new harddisk so that I...
Summary: Hi everyone, I was wondering if it is possible to add a new device to an existing Raid-5 without loosing all the data on the exsiting array (kind of d...
Summary: Hi all If suppose my root drive is not having sufficient disk space and that is in hardware RAID 5 .if support i am adding one more hdd in raid 5 , ho...
Summary: Hmmm, maybe i should wait. sept isnt far off. but if i do upgrade (using all 3 discs) will it erase my old configurations? (like my desktop prefs and ...
Summary: I'm doing something very similar and works rather well. I didn't see anything in your comments about masquerading.. so I must ask have you enabled t...
Summary: What will it serve? Just for backup? If so then there will be no problem using it for multiply tasks, like firewall, dhcp, routing, etc. If you had a ...
Summary: I have a similar problem but use lilo. My main computer is running Mandrake 9.0 and I am going to try to set-up some diskless workstations to do littl...
Summary: Ok folks, this is the deal. I got a 40 gig HD. As of now this is how it is setup (Installed in the following chronological order): Primary 1 (C:\): Wi...
Summary: I don't know exactly what your going to be using this box for but I will make some assumptions. Lets assume your using the box for total desktop use....
Summary: Franklin Castillo, Your are really low on RAM. You need to get to, at least 16 MB. Your pentium board must be capable of more. Unless you have an over...
Summary: I'm trying to get a WaveLAN Turbo Gold card working with my Compaq Armada 7380DMT laptop, but can only get as far as getting a single green light alwa...
Summary: Damn, it seems the only way for me to use 1024x768 is by having a refresh rate of 43.0 - 44.5, but I remember when I was using XFree 3.3.6 by using th...
Summary: Hello all, I have the following config: MSI K7T266 Pro Raid 256 MB DDR (266) 2* IBM Deskstar 40 Gb in Raid-0 Primary partition: W98SE (FAT32) Logical ...
Summary: I've had my linux machine purring along since January without a hitch. Earlier this week the system was shutdown by one of the kids using the power s...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
