Summary: my 3com NIC isn't working in NT. NT detected the 3com drivers when I first installed the card and clicked on network properties but the card isn't li...
Summary: What we do at our office is put NT on a 2GB drive (as NT cannot detect a drive bigger than 8GB i think it is) and partition the rest out through the d...
Summary: I found a lot of driver but will all of them i had de same problem.NT doesnt detect the modem.You do this manually .But the ras canīt see it.When you ...
Summary: Something else to consider: What service pack are you running on your Dell? If you install SP4 on the system, you can then go and install the fil...
Summary: I have the same problem. However, the vendor I got my machine from had a setup program in addition to the drivers. This setup program, when run in W...
Summary: Tape device installed in server for several months with no problem. After rebooting from a power failure NT cannot detect the tape device. Drivers a...
Summary: Actually NTFS does not have the 2GB limit (though your computer's BIOS might if it's an older machine). The problem is more likely the fact that you a...
Summary: When I install the 3c905B card in a PCI slot with Windows NT 4.0, the registry entries made include a key called SlotNumber which identifies the PCI s...
Summary: did you verify that these cards are on the hcl hardware compatability list for nt? Is your 486 a 33hhz with over 20mb ram min.? What protocol are yo...
Summary: I recently loaded NT 4.0 and am now having problems with my video display and sound card. If I try to change the video adapter to load the drivers for...
Summary: The network card should be detected regardless of the protocols you may install. It depends only on the drivers & WinNT interaction. If it's not being...
Summary: You shouldnt have to how old is the PC you are using it should be detected if anything once the drive is connected and you boot into the system in con...
Summary: SKIP ADAPTEC. Here is the answer to your question. You have to load the drivers for your SCSI card prior to NT setup detecting the devices on your sy...
Summary: I had the same problem just a few weeks ago. The problem was that the NT installer, detects the SCSI hardware and installs the drivers, but some files...
Summary: Hi all, We have swapped windows NT Hard disk to another dell machine. after i add com 3, Event viewer showing that "while validating that com3 was r...
Summary: If you've never had a sound board before on your NT system, you've probably never installed pnpISA.sys NT 4.0 supports Plug-and-Play ISA devices, but ...
Summary: Max FAT16 area in DOS, '9x = 2Gig; in NT = 4Gig.; in '98 under FAT32 = noticeably larger; similarly for NT under NTFS... Dual-boot NT/'9x requires a F...
Summary: i try to install nt server on brand new h.d nt couldnt detect it. and i guss its a some kind of boot sector virus. does anyone know about a good way ...
Summary: HI Experts, I have added another CPU to my NT Server.Is there any way where NT will detect this CPU without reloading NT. Thanx in advance....
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
