Summary: ok, when i turn on the power the compy starts to run.. but the monitor just flashes. I tried to clear cmos by removing the battery for 30 seconds.. s...
Summary: This MOBO is listed nowhere. It's working fine but is stuck in 'on-board' sound. I can't identify the jumpers to disable it and let my sound prog work...
Summary: Hi I have to reset the jumpers on the motherboard every time I turn on or else it just wont start I can restart but as soon as I power off it wont bo...
Summary: I have a harddrive that crashed and was password protected. It is now a backup hard drive with files on it that I need. The only problem is that I s...
Summary: Should I set jumper settings on my hard drive to cable select or master? I have P4 w/intel motherboard Western Digital 60 gb hard drive Hard drive is...
Summary: Hi I'm building a music server to run for commercials on air, and we're building a PC from scratch. What we have, is 3 Hard drives (1 80g, 2 12gs) an...
Summary: Hi, I bought a 40gb seagate Hdd and set the jumpers by mistake to 32gb limit size. I corrected the position to master setting jumper and it stills sho...
Summary: I've had a motherload of problems not being able to access files on my old C: drive which is now installed as the E: drive on my new system, which run...
Summary: I installed a new dvd drive in my pc, and I had some programs that needed to be deleted out of my start up menu for a clean boot. How they got there I...
Summary: Hey, I have a friend with computer troubles. According to what he says, when he goes to start his computer, a black screen with grey writing appears. ...
Summary: when i boot up my gateway E4200 it keeps entering configuration mode after pressin esc and pressing yes to the prompt to discard all changes i get an ...
Summary: Did you set the jumpers to the correct setting on the hard drive (master or slave)? You can find these settings by going to the manufacturer's website...
Summary: Oh dear :-( A couple of things to try, first try resetting the bios. Most motherboards either have a jumper on the Mobo to do this or require the CMO...
Summary: The BIOS is independent from any OS, so booting from your hard drive, diskette or CD is in no way going to be terribly helpful - fwiw, disk I/O error ...
Summary: switch their positions on the cable and change their jumpers in the back of each HD. then reinstall everything because you wont be able to boot.the MB...
Summary: This is a small extract from the links provided . http://www.ultratech-llc.com/KB/ASP/FileView.asp?File=/KB/BSOD.TXT http://www.ultratech-llc.com/KB/?...
Summary: Considering that all cables are good, jumpers are correct the ide bus is ok and power is available (replacing the cable is easy and could save a lot o...
Summary: I have 2 simpletech external hd 250GB.My boss dropped one of them, killing the hd. The enclosure still works, I tested it out by putting the hd of the...
Summary: I have 2 PC's. One Compaq deskjet and another hand built one. Both have winXP. The CDrw works fine on the Compaq. The other machine detects the driver...
Summary: I'm guessing your soundblaster16 is one of the models which used to have an on-built IDE connector for CD-ROM drives, because they used to sell CD-ROM...
Summary: 2 points 1. Because 2k installed on different hardware it may not boot at all in new machine. Or it may boot and sort out new drivers properly. ry it ...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
