Summary: Please help, my new PIII is stuck! When booting, it prompts "non system disk/please insert...". I did boot from the original floppy, went ok, could ch...
Summary: when I start my computer it gives me the error "Invalid media type reading drive C Abort,Retry,Fail?" Anyone have any idea how to fix this one?? i'm...
Summary: I just loaded DOS 6.22 on a government machine and when I try to format the drive in says "Invalid media type reading drive C". I can't figure out th...
Summary: I have a similar problem with my recently acquired second hand laptop (a 486 SLC with 4 MB of RAM and 1.2 GB of hard-drive) I got a complete MS-DOS 6....
Summary: I've spent hours trying to load my old computer up with windows after formatting the c drive - when I re-boot the computer does not recognise either m...
Summary: I have the following problem with my recently acquired second-hand laptop (a 486 SLC with 4 MB of RAM and 1.2 GB of hard-drive). I downloaded a compl...
Summary: I have an IBM 300gl with no operating system. I tried to do a FDISK extended and now the computer will not recognize the C: drive. Actual response i...
Summary: Hi, I am facing a problem if I put DOS=HIGH,UMB if config.sys file, It gives message "Invalid Media type reading drive D" where D is my USB Pen drive....
Summary: I finally got a partition to work and checked it. But now i am trying to put some files in it from dos and it says "invalid media type reading drive C...
Summary: I have booted from a dosboot disk with ASPI USB DRIVERS and hairu masstoreage device driver. The USB ports are recognised and the device is found, wh...
Summary: I fdisk my hard drive. I dont believe I did it correctly. Now I get a message "Invalid media type reading drive c". I can access the a dive and boot i...
Summary: I have the following problem with my recently acquired second-hand laptop (a 486 SLC with 4 MB of RAM and 1.2 GB of hard-drive). I downloaded a compl...
Summary: I am attempting to add a portion to a batch file which will check to see if the c drive is formatted, and if not offer the option to format it. I am ...
Summary: My Norton Systemworks 2002 Rescue Disk boots to WIN98. I found PCDOS installation diskettes in my "archives" and used the first to format a boot disk....
Summary: I am trying to reform a C: drive on a 486-DX and install MS-DOS 5.0. I have booted from a bootable a: disk, but when I type format c:/s, I get a "inva...
Summary: Here's what I did to fix this problem. Using another computer get the following downloads. GOTO http://www.toshiba.com/html/products.htm CLICK Comput...
Summary: I have the following problem with my recently acquired second-hand laptop (a 486 SLC with 4 MB of RAM and 1.2 GB of hard-drive). I downloaded a compl...
Summary: My mate Pamela had a major failure on her computer - wouldn't boot at all. I got some advice through the Windows 3.11 forum which enabled me to get t...
Summary: Hey, I've got an old 486 that was running win3.11 until a couple of days ago when a whole lot of files (like all of windows and command.com) got accid...
Summary: Im not sure if this is a dos or win 98 question. but im in dos at the moment. My computer was set up with NT4 and two 2G partitions. I want to install...
Summary: ok i looked at a help page on this subject and i followed its directions. it told me to run fdisk from the a drive and creat a new partition. i did ...
Summary: I dont know what happen after put fdisk I make something wrong my hard drive when start say missing operating system ,I put the boot disk when i want ...
Summary: I ran into the exact situation described above recently: In order to clean a hd [that I thought just might have been infected by a virus after it...
Summary: Computer crashed whilst using Windows 95 with the error message that I need to reinstall windows. Upon rebooting I get an error message that I have no...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
