Summary: I'm unsure of the error, but why did you put it on an external harddrive. Its not something you are going to be able to walk around with and plug i...
Summary: I have tried installing on an external USB2 connected drive, without success. USB only for backup? I am going to install an IEEE 1394 firewire card, ...
Summary: Many distros offer a live cd/dvd. You simply boot to the disk and run it from the disk, No need to install anything.You don't need to use an external ...
Summary: How do I install Suse 7.3 on my Intel P3-933? The site http://www.linuxiso.org/suse.html tells me that I can't install on an Intel/AMD chipset compute...
Summary: I'm newish to Linux. I would try out a Live cd to start. Or try installing ubuntu with wubi. This installs ubuntu via windows. So it is in the add/rem...
Summary: Welcome to the hair pulling club. I'm pretty sure GRUB should have been installed on the external disk. Your Vista disk should allow you to do a "fix...
Summary: Adam - Good luck running OpenOffice with 64 meg or less (If it IS 32 meg you have, there's basically no way it's going to happen) and 64 meg will requ...
Summary: I too have a Solo 2100, and I don't have an internal Hard Drive. I one was able to get a Mandrake 7.2 loaded using an external PCMCIA CD-Rom. Since th...
Summary: I have a Linux Slackware software, which I want to install on HP m/c with OS winMe. Problem at my side is that, even after instalation completed and p...
Summary: I am assuming you want to do a dual boot with a Windows system which is installed on drive C. When Redhat asks you where you want to install the OS, d...
Summary: I am new to linux and I would really appreciate some help concerning the installation of linux on an "old" pentium. Which linux do you think is best s...
Summary: I used PartitionExpert 2003 to swap them. Later today I tryed the following: Switching 2 drives and formating an empty one, so my system now looks li...
Summary: If your going to put Linux only on your external disk don't install a boot loader ,instead make a couple of floppies with the boot.img to boot from ...
Summary: If you have burned the CDs correctly and your machine is set to boot from CD, the installer on the first disk presents an easy GUI installation. Try i...
Summary: I have installed several times all versions of RH from 6.1 to 8.0 on on AMD athlon 1GHz on an ASUS A7V mobo and also on an P IV 1.7GHZ on a TYAN T...
Summary: 1)I am running XP on an existing disk. 2)I added a new hard disk which the BIOS recognises. But XP does not recognise it as yet, which I assume is OK ...
Summary: I see that you are using a pentium 2 with 333 Mhz. I also like linux and I have a RH9 installed on an AMD K2 with 55o MHz, it is really slow at least ...
Summary: Alrite, heres my problem: I am trying to install linux mandrake on my machine on the secondary hard disk. When I completed the installation, linux se...
Summary: Hi kumar Do you have a USB Hard Drive ? It is quite difficult to install any operating system on an external hard drive for the following reaso...
Summary: I am having MAJOR problems using an external USB disk as a backup device with SuSE 10.2. Basically, USB seems to be incredibly slow. On a 320GB LaCie...
Summary: I did a clean install of WinXP Pro followed by RedHat 8.0. I use GRUB. It works fine for me. If you think that the grub boot information is correct yo...
Summary: Hey all, My History: I've installed Mandrake a few times, but I've always done it the easy way. I tried to run a full install of Mandrake on an old ...
Summary: You can check the grub boot information in the file: /boot/grub/grub.conf You might want to post you grub.conf file. I might see something there. I am...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
