Summary: I have a PCI bus master IDE controller problem that is similar to those on this forum (i.e. the BIOS Code 29 error). However, I've spent the past th...
Summary: remove the ide controller and reboot your machine. That will install the driver again and then try installing over the top if that doesn't fix your pr...
Summary: I got exactly the same problem, the same day. I've done a lot of investigation, spent hours on support lines, tried all sorts of things. For me, the I...
Summary: SETUP: P166MMX 2 HD's 6.4GB (windows98) 1.7GB (linux) Creative Labs 24x CD-ROM Iomega Int IDE Zip-100 The system has beed working 100% for a ...
Summary: Somehow my Primary (and secondary) IDE controllers have run into problems. They both show up as conflicts (yellow exclamations) in the control panel->...
Summary: I have looked through alot of past post, contacted Compag and tried some other things and I still have a problem. My computer worked fine until I upd...
Summary: I need HELP! I've had this problem two times now with two different boards and I'm at my wit's end. The problem I'm having is Windows 95 will detect...
Summary: When trying to install software and hardware for a digital camera Image Card Reader the PC crashed and wouldn't start windows (98). I've removed the ...
Summary: Hi everyone, yesterday i fomat my hard drive for some reason and I reinstall win95 after that i had some problem with my cdrom it don't detect some mu...
Summary: Can anybody help to cure a problem I have with the secondary IDE controller on my system. I am running win 98 and the drivers for the device are insta...
Summary: You do not need to download any drivers as they are built into Windows. That is just a general statement it uses for any hardware device that is not w...
Summary: Hi I'm helping a friend fit a new cdrom drive and a new zip drive to his computer as his previous cdrom drive died. The problem is that they are not b...
Summary: i gotta buddy with a problem, he installed a cd-rom with the pc running....yeah,thats right, running. his surge tripped and when he got it to reboot h...
Summary: I have a problem in Windows with the primary and secondary IDE controllers working properly. Both of them have yellow exclamation mark by them in Devi...
Summary: Code 10 If the device has a "FailReasonString" value in its hardware key, that string is displayed as the error message. The driver or enumerator pla...
Summary: AUGGHHHH! BEWARE! LOTS OF TECHNICAL MUMBO-JUMBO FOLLOWS: I am having problems trying to fix a Compaq Armada 1571DM Laptop. I recently formatted the ...
Summary: check to see if your running in dos compatability mode (system properties performance tab) go into safe mode remove all ide controllers reboot see if ...
Summary: Well, in win '98 this problem can be fixed using the following. IF it is an ide-controller problem : start > run > regedit once that comes up, do a s...
Summary: With Primary IDE controller enabled pc will only start up in safe mode, if i enable secondary IDE controller pc will start up but shows a yellow sign ...
Summary: I found that there are an yellow Exclamation mark (!)in "Primary IDE Controller" and "Secondary IDE Controller" on my device manager. Is this the rea...
Summary: My new Athlon 800 has been working fine for two weeks, when today it appeared to load up normally but my CDR and DVDROM drives had disappeared. If I r...
Summary: I'm pretty new to computers and can use all the help I can get. The problem is--I upgraded to a new CD-ROM about a year or so ago, and it's run OK for...
Summary: Hi, I have a pci ide controller in the other devices folder of the devise manager with an ! mark over a ? mark. This problem is a primary reason my C ...
Summary: When checking problem devices I get this message: Primary IDE controller (single fifo) hde This device has a problem: code=29 (Ox1D) This device has b...
Summary: A known problem with Opti chipsets, it also effects "standard" IDE controllers. If windows fails to load protected mode drivers for the HDD controller...