Summary: We use a Linux server to act as router for local network accessing Internet and it's necessary to let local machine access ftp server on the Internet....
Summary: how to setup a iptables, squid(proxy), ldap and nat on linux whitebox... i installed all the components and everything works ok... i made a iptables s...
Summary: I am in the process of trying to setup iptables as a software firewall for my linux box. I have been able to block all incoming requests. However, I a...
Summary: I am new to linux and do not know how to setup bellsouth fastacces dsl to mandrake linux 9.0 can u plz tell me the exact steps....????????please help ...
Summary: hii alll i think some one may help me i am new to linux ...., i wan to learn linux firewall i wan tto know how to install iptables and how to write ...
Summary: Hello, I need to setup iptables so that my clients can access their e-mail using e-mail programs such as Outlook, Outlook Express and so on. How...
Summary: Hi all folks, RH9.0 ===== Can you help me recall a small program to stop iptables permanently so that it would not start to run on booting. This prog...
Summary: Hi all folks, RH8.0 KDE desktop OpenOffice 1.0.1 Internal modem ================ Kindly advise how to setup a fax printer and efax. Pointers would be...
Summary: Hi All People, RH7.3 ==== I tried to setup a HP Deskjet 690C printer on KDE following K_Start --> System --> CUPS Printer Configuration It required d...
Summary: I am trying to setup iptables for use as my firewall. I can configure it fine, but how to I get my settings saved and loaded when linux starts? I trie...
Summary: Folowing many introductions about how to setup adsl for Linux ,I have setup adsl for Linux many times,but it cannot connected to internet.What should ...
Summary: Can anyone tell me the step to setup a small client server network which is running under Linux RedHat9? Or please show me if you have any references....
Summary: I was trying to setup IPTABLES. DUring the compile portion, the command "make pending-patches KERNEL_DIR" needs to be entered. I enter make pending-pa...
Summary: I think you have to setup your email program too. Can you save the doc as some type of file and then send it normally as an attached file? I read it w...
Summary: Hi all, I would like to setup an iptables firewall that blocks all incoming and outgoing packets except for http, pop3, smtp and ssh. Would this setup...
Summary: I am new to the Linux OS I have just installed RH9.0 and I am going to use it as an Internet gateway Server for my Home network consisting of four wor...
Summary: Does anyone have any ideas why the minute I install a network card into my computer, I'm then unable to browse the internet. using ifconfig I can ping...
Summary: Hi, I have Mandrake 10 Official, and I am currently using KDE 3.2 BRANCH >= 20040204. I have successfully downloaded and compiled KDE 3.3 from source ...
Summary: Hi, I want to setup a firewall with IPTABLES in order to work with packet filtering and masquerade....but in the same PC I don't know if it's possible...
Summary: Note: I using the Linux:/# as the linux command prompt below IPSec with FreeSWan as the server and SSH Sentinel 1.31 as the windows client Here is...
Summary: Hi All, I have been pulling my hair out over the last week trying to figure this out. I have read everything that I have found on routes and the...
Summary: I am new in linux and forced to setup urgently (it is my decision) a kind of gateway. For obvious reasons I'm trying to keep on via GUI - impossible t...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
