Summary: Many thanks to all who took time to help. I'm VERY new to computers, so I'll be moving very cautiously here. Response to-- Name: techtony Date: Novemb...
Summary: Adding CDRW. Windows will not recognize 2 cd roms. Regardless of how they are jumpered Windows will recognize them accordingly individually but not bo...
Summary: I am having pretty much the same trouble as all of you. I upgraded the hard drive to a 15 gig and everything was fine in windows 98. Once I upgraded...
Summary: Check for a NOIDE entry in the Registry. Open the Registry editor (START-RUN-Type,REGEDIT-Click OK). After the Registry editor opens navigate to the...
Summary: When checking problem devices I get this message: Primary IDE controller (single fifo) hde This device has a problem: code=29 (Ox1D) This device has b...
Summary: The controler that the cd-rom is hooked to (ide controler or scsi controller) See if this controler has a yellow ! next to it in device manager. It'...
Summary: Hello sir! I'm having problem with primary ide controller(dual fifo).In device manager it is shown with exclamation mark.In properties it shows proble...
Summary: My system will detect my CD rom drive, and in the control panel it says it is working properly, but It will not read anything... Can someone help me??...
Summary: Hi there, I have a problem I hope someone can help me with (I've checked he registry before you say it, no entry marked noide in there) I bought a new...
Summary: Somehow my Primary (and secondary) IDE controllers have run into problems. They both show up as conflicts (yellow exclamations) in the control panel->...
Summary: You should have a primary and secondary IDE controller on your motherboard. On your primary, you have to have a hard drive. Put the one with the mos...
Summary: I am running Windows 98 second edition. I have two hard drives on the first channel and two cd-roms on the second channel. I am no longer able to acc...
Summary: The NOIDE entry is placed in the Registry when conflicts arise in the Primary and Secondary Ide Controllers. This NOIDE entry inhibits the Protected M...
Summary: exclamation point before primary and secondary IDE controller in window "system-periperal" and get no installation of CD-rom drive in win98 but wel un...
Summary: I have had no problems with Win95.After installing Win98SE There is a problem with Intel 82371AB PCI Bus Master IDE Controler, Primary IDE Controler(d...
Summary: Is the CD-ROM shown in the Device Manager? Are there yellow exclamation marks in front of the Primary and Secondary Ide Controllers? Is the system op...
Summary: Hi Frends, I recently did hard disk format using two hard disk as I wanted to make a backup of the hard disk which I am formatting. I did the format i...
Summary: hi, I have a M.B. Gigabyte GA-5SMMM. the problem is what the CD-ROM drive not show in my PC. I replace the drive and the problem persist. I formated a...
Summary: For some reason there's an exclamation point on my Primary IDE controller (dual fifo). I've reinstalled system drivers but it's done no good. I have...
Summary: According to my system information my primary IDE Controller has a problem. It states that it has been disabled in the hardware and that the code=29(0...
Summary: Many drives are type 47. If it really is type 40 it may be a non eide drive requiring dos mode. Look in performence tab of system. If the cd is on the...
Summary: Hello—I have a minor problem (I think) and hopefully you will be able to assist in the solving of this. Recently when I have been on my computer ever...
Summary: I have an IDE Toshiba CD-ROM drive and I just recently bought a SCSI Yamaha CDRW drive. I'm running the Toshiba off of the motherboard and I'm runnin...
Summary: It has a /!\ yellow triangle and it said the drivers were either not working or not installed,.. That main problem now is that when I formatted and ...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
