Summary: my father has a hard drive that stopped working. the first thought was that it was the mother board. the first problem was the usb ports or drivers s...
Summary: Western Digital hard drives have a Master Alone jumper setting which you must use. I stated that above. You may also need to change the boot order an...
Summary: Oh and meant to say, had tried hooking the drive up to my desktop and my controllers couldn't recognize it, which leads me to think it's something wit...
Summary: I have an old Maxtor hard drive model AT 7245 that has a bit of data upon it that I need. I need to set it up as a slave drive for next couple of day...
Summary: Hello I am having trouble setting up a dual boot for my system. I have two hard drives, both IDE. One is drive(0) and the other is drive(1) I have XP ...
Summary: i m trying to set up my 2nd domain under godady Linux hosting account .after defining the folder i m trying to ping my site but its not working .pleas...
Summary: Which type of setting get loosed by you, i don't think so that their should be any problem unless the drivers are nor properly installed in the comput...
Summary: The laptop that I use has to go back to the IT people for to be "re-imaged" and all my settings,updates, downloaded software etc.will disappear. The l...
Summary: Has it ever worked?? I had a similar problem with my desktop, and as far as I remember (it was a while ago) it was because the conifiguration of maste...
Summary: My problem is I had a friend (re)build me a computer from my folks old system, guy did a great job and all tons of colorful lighted fans n everything....
Summary: From "secondary master" I assume this is an IDE drive(40 pin connector with a wide ribbon cable). How is the drive jumpered? Is it alone on the cable?...
Summary: Hmm. This is happening _AFTER_ replacing the CMOS battery. The old one tested 2.99V in circuit, but I replaced it anyway. The new one tests 3.28V i...
Summary: I recently experienced a similar issue when replacing an old motherboard with a new one(all the other components were the same - also with a third par...
Summary: The need for speed goes on unabated, but fulfilling that need became a bit less likely with Intel’s decision to wait until 2011 to integrate support...
Summary: The Amp has lots of inputs (i.e. tape, phono, aux, etc.) but the only output is the headphone socket or speaker cables. I only have the one cable but ...
Summary: To start with, you're posting in the wrong forum.... And you need to know three simple rules when overclocking an Intel system: 1. the faster the FSB,...
Summary: check cmos/bios setup order? Not sure how that is done but I usually get A:ditve if I use the floppy and C if I use the CD rom to try and do a start u...
Summary: the computer will restart automatically if the BIOS is corrupted --- please reset it using the CMOS battery ( or CLR_CMOS jumper, if desirable ) ...
Summary: OK, so I saving up to buy the parts for a new PC and wanted to get some opinions on my choice of Hardware and what OS to choose, (XP Vista or 7) depe...
Summary: Hai guys i learnd hardware newly.at institute they didnt tell me how to measure the smps output voltages (Core: 1,Core 2,+12V,-12V,+5V,5V,+3.3) using ...
Summary: Control Panel -> Classic View -> Power Options -> "adjust the display brightness" on the left hand side -> Set the brightness for when it is plugged i...
Summary: Hi. Here is the story. I have 6 pc running on a LAN with 1 of them acts as print server. I would like to know if there is any way to make this happen;...
![[higher confidence]](http://static.computing.net/img/AT-red_x.gif)
- higher confidence, ![[lower confidence]](http://static.computing.net/img/AT-black_x.gif)
- lower confidence
