Need ghost SCSI to IDE or sata,pls advice

June 9, 2009 at 11:27:36
Specs: Windows Vista
I have two 40gb SCSI on a xp system.It has IDE and SATa ports also.
I have decided to go for ghost from SCSI to IDE.because sometime hard disk has mechanical struck up in rotation.i tried by partition magic8.05.i connected the IDE through convertor to USB.but the IDE drive was not detected in the drive details.pls advcie
agfa1@yiacokuwait.com or
helloravicharles@googlemail.com

See More: Need ghost SCSI to IDE or sata,pls advice

Report •


#1
June 9, 2009 at 13:19:19
Spammers are always glad when you post your email addresses publically so they can harvest them.

Scsi and ide drivers must be loaded for PM to be able to address the drives.

You should be replacing scsi with scsi. But if you want to do ide you must do ide not ide to usb to ide.

You do understand that you won't boot/load the OS until you have done a repair install of the transferred OS.


Report •

#2
June 9, 2009 at 13:25:48
mmm - echoing "wanderer" re' your email addresses...

Strongly advise you edit your original post to remove those addresses... Or be prepared for loads of junk mail etc...; which means you will need to dump those addresses and start/obtain/use new addresses - which you "never" post in public...?

Likely you will end up replacing those addresses even now as the harvesters will likely have found them already?


Report •

Related Solutions


Ask Question