|":Bah dink bah dunk, bah dink bah dink...... bah dunk"|
Like a door bell sound ?
The same as when you plug in another USB device ?
Dong ding (lower tone, higher tone), when you plug it in, Ding dong (higher tone, lower tone) when you unplug it ?
Card readers usually do not need third party drivers - they usually use generic drivers that are built into Windows.
Older card readers often can't read higher capacity memory cards or newer types of memory cards - there's nothing you can do about that - it's a limitation of their circuitry.
Update - Most card readers connect to a USB port connection either internally or externally.
If you were getting a message when you plug in a memory card or something else that requires USB 2.0 support to work best This device will work better if you plugged it into a USB port that supports USB 2.0 specs or similar
-preferably it should be plugged into a USB port (or USB header on the mboard) that suppports USB 2.0 specs. If the mboard was made in about 2003 or later, it does.
- XP must have SP1 or later updates installed in it in order for it to support USB 2.0 controllers and devices.
- after you have installed XP from scratch, after Setup has finished, you must load the main chipset drivers for the mboard in order for Windows XP SP1 or later to actually install the USB 2.0 support.