Tom's Guide | Tom's Hardware | Tom's Games
 |
 |
 |
When the Ras service is started i'll receive an errorcode 1066, so RAS is not working.
I hope someone knws this error.Thanks....
http://support.microsoft.com/support/kb/articles/q106/2/04.asp
To correct this issue, you will need to do one of the following:Configure one or more ports to receive calls using the following steps:
Windows NT version 4.0
----------------------1. Click Start, point to Settings, and click Control Panel.
2. Double-click Network, click Services, click Remote Access Service,
and click Properties.3. Select one of the installed ports and click Configure.
4. Click either Receive calls only or Dial out and Receive calls.
5. Click Close, click Continue, click Close, and restart Windows NT
when prompted.
0 
From the Microsoft Website:
http://support.microsoft.com/support/kb/articles/q106/2/04.asp
To correct this issue, you will need to do one of the following:Configure one or more ports to receive calls using the following steps:
Windows NT version 4.0
----------------------1. Click Start, point to Settings,
and click Control Panel.2. Double-click Network, click Services,
click Remote Access Service,
and click Properties.3. Select one of the installed ports and
click Configure.4. Click either Receive calls only or Dial
out and Receive calls.5. Click Close, click Continue, click
Close, and restart Windows NT when prompted.
0  |
 |
 |
This post is quite old and has been locked from receiving new replies. Please create a new posting instead.
| Ads by Google |
