|
|
|
Missing File or Corrupted Himen.sys ..error in config.sys on line 2
|
Original Message
|
Name: AL
Date: April 29, 1999 at 16:53:44 Pacific
Subject: Missing File or Corrupted Himen.sys ..error in config.sys on line 2 |
Comment: When I on my pc, my computer says disk boot failure. So I enter my system disk. Then it says missing file or corrupted Himen.sys. It also says error in config.sys line 2. I cannot access C drive after I insert my boot diskette. I cannot copy thus the a new cofig.sys to my c drive to replace the error. Any idea?
Report Offensive Message For Removal
|
|
Response Number 3
|
Name: DC
Date: May 3, 1999 at 16:04:42 Pacific
|
Reply: (edit)Might try checking your BIOS before you give up. See if your hard drive is still listed under "Primary Master" or "Secondary Master", etc.
If it isn't, configure it properly.
If it is, looks like trouble.
 Report Offensive Follow Up For Removal
|
|
Response Number 4
|
Name: Rob
Date: May 4, 1999 at 07:45:38 Pacific
|
Reply: (edit)Try getting some drivers for your cd-rom and install them. then reload windows on to your hard drive and it should copy the files back.
Report Offensive Follow Up For Removal
|
|
Response Number 5
|
Name: Smarty
Date: February 19, 2000 at 16:24:47 Pacific
|
Reply: (edit)Well, looks like your windows is gone, you have to reinstall windows....and its always better to format your hard drive first....
Report Offensive Follow Up For Removal
|
|
Response Number 6
|
Name: DEBBIE
Date: February 21, 2000 at 16:48:59 Pacific
|
Reply: (edit)I NEED THE FILE HIMEN.SYS FOR WINDOWS 95 CAN SOME ONE SEND IT TO ME IN MY EMAIL ADDRESS I WOULD THANK YOU IF YOU COULD SEND IT TO ME I NEED IT REAL BAD I'M DOWN WITHOUT IT PLEASE HELP ME DEBBIE EMAIL ADDRESS IS DWELCH1028@AOL.COM
Report Offensive Follow Up For Removal
|
|
Response Number 8
|
Name: Steven Shands
Date: June 7, 2000 at 18:11:02 Pacific
|
Reply: (edit)I have the same problem too, could someone send me it or anything so i can just start my computer up then i would be able to fix it
Report Offensive Follow Up For Removal
|
|
Response Number 9
|
Name: Brandden Hesse
Date: June 24, 2000 at 10:25:11 Pacific
|
Reply: (edit)I just bought a new motherboard, installed it, and used the old memory out of my HP Pavilion, lately ive been getting "While initializing device VKD: Windows protection error you need to restart your computer, then when I hit a button a few times I get, Internal Stacks overflow, change the stacks settings in your config.sys file and try again. The motherboard tech said it's in the memory and told me to buy some new memory, I did and i still get it, not as much but it still happens, does anyone have any ideas at all? Please help
Report Offensive Follow Up For Removal
|
|
Response Number 10
|
Name: justin
Date: August 6, 2000 at 22:54:39 Pacific
|
Reply: (edit)I NEED THE FILE HIMEN.SYS FOR WINDOWS 95 CAN SOME ONE SEND IT TO ME IN MY EMAIL ADDRESS I WOULD THANK YOU IF YOU COULD SEND IT TO ME I NEED IT REAL BAD I'M DOWN WITHOUT IT PLEASE HELP ME! jtjersey5@aol.com
Report Offensive Follow Up For Removal
|
|
Response Number 11
|
Name: Teresa Belanger
Date: October 7, 2000 at 08:53:32 Pacific
|
Reply: (edit)I need the file too but am not very computer saavy. If you email it to me, how do I access it or will it work by just being on my system in my email.If so this is my roommates computer and IM DEAD! If I cant fix it. omebody Please help! My webtv addy in case someone has a suggestion is bugsbunnilvr@webtv.net Thank You VERY MUCH!
Teresa
Report Offensive Follow Up For Removal
|
|
Response Number 12
|
Name: Robert Piper
Date: October 18, 2000 at 05:36:33 Pacific
|
Reply: (edit)try starting your comp with the boot disk and at the dos prompt type sys c: this will transfer the system files to your c drive and replace himem.sys then press ctl or f8 and do a confirmation load not loading windows drivers, this will get you into safe mode and allow you to use the internet. edit the config.sys file using msconfig.exe
Report Offensive Follow Up For Removal
|
|
Response Number 13
|
Name: Larry A Hill Jr
Date: November 2, 2000 at 20:39:59 Pacific
|
Reply: (edit)i have the problem in windows 3.1 as it is i have to boot up the computer and re-install windows 3.1 everytime that i wanna use it,anyone out there willing to help me out as to what to do?,if so E-Mail me at ICEWIND_29@lycos.com
Report Offensive Follow Up For Removal
|
|
Response Number 14
|
Name: nita
Date: December 3, 2000 at 06:18:29 Pacific
|
Reply: (edit)i am trying to reformat a harddrive and it won`t let me. i am missing this file as well along with config.sys line 6 and 9 and also it tells me that e.g.,(c:\windows\command.com) is corrupted or missing please help. I am trying to fix this for a freind of mine
Report Offensive Follow Up For Removal
|
|
Response Number 15
|
Name: arthurgilla
Date: December 5, 2000 at 06:14:42 Pacific
|
Reply: (edit)I'm fixing a computer for a freind and I had to start over from scratch all of the o/s and I got the drivers the only problem now is that the cd-rom dosn't have a valid drive I do have the drivers but the PnP isn't reconizing it although the computer see's it I just don't know the correct line to put in config.sys
Report Offensive Follow Up For Removal
|
Use following form to reply to current message:
|
|
|
