I am keep receiving an error messages after I run the setup for windows95, because i format my hard disk and now I am trying to setup windows95 but I am getting this error message " There is not enough free econventional memory to check a drive. You may need to remark (REM) some device drivers from your config.sys or in your config.sys, you may need to load the EMM386.exe driver to load your other devide drivers into Upper Memory Block using DEVICEHIGH=statement. Please help me with this problem..Thank you in Advance

try these command at the dos prompt they skip the memory ck the scandisk the warenty ck and the cross link file scan SETUP.EXE /IS /IQ /IM /IW

in addition and foremost boot from a clean disk with just the cdrom drivers

Thanks, but I tried the Setup/IS and i got the error message bad name etc. but I will try again...where can I put those commands ..should i type it on C:\, d:\ or a:\ and also what clean disk should I use the startup disk? What if I will going to format my hard drive again FORMT C:\ Do you think it will going to work?

I got this error message again, " Cannot Start Windows on Standard Mode" Try Starting Windows in 386 enhanced mode by typing win/3" Please help me, I am getting a little frustrated, with this kind of situation..