I have a 386 computer. Upon booting I get Phoenix 80386 Rom Bios Plus Siemens Nixdorf Informationssysteme AG 386/20 Mhz Version 2.0/06 640k Base Memory, 7168k Extended I have installed Dos 6.22 and WFWG 3.11. All seems well during installation, but once fully installed the system reboots MS-DOS starts, Himem is tested, and MODE prepares and selects code page function. Then when windows kicks in I get the initial start up screen then I get the message:- "Cannot find or load required file KRNL386.exe. The path was not found." I have copied the file to every directory on my hard drive and still I get the same message. Also when I get this message and type:- dir I get file not found. My config.sys file is:- DEVICE=C:\DOS\SETVER.exe DEVICE=C:\WINDOWS\HIMEM.SYS DOS=HIGH COUNTRY=044,,C:\DOS\COUNTRY.SYS DEVICE=C:\DOS\DISPLAY.SYS CON=(EGA,,1) FILES=30 DEVICE=C:\WINDOWS\IFSHLP.SYS STACKS=9,256 My autoexec.bat file is:- @ECHO OFF C:\SMARTDRV.exe PROMPT $P$G PATH C:\WINDOWS;C:\DOS SET TEMP=C:\DOS MODE CON CODEPAGE PREPARE=((437) C:\DOS\EGA.CPI) MODE CON CODEPAGE SELECT=437 KEYB UK,,C:\DOS\KEYBOARD.SYS Please help me E