Hi: I have several sun clone ("Horizon") boxes, ultra 2's. Some of them have an Integrix S20V sbus frame buffer card in them. When I upgrade from 2.8 -> 2.8, I got a request to upgrade the firmware with the "Flash" prom CD that comes with sol 8 install set. Looke at the sun site, and confirmed my firmware was out of date, so did the upgrade. Note that I at first declined the upgrade and the system came up fine after the upgrade to 2.8 but complained about the firmware being out of date every bootup. After doing the firmware update, which seemed successful, I get the following on bootup: "Can't find driver for console framebuffer" and XWindows can't start, so only have text available now at the console. Help! Any ideas on how to get a driver for this thing? Sent a msg to support @ integrix but no response as of yet. The same box with a Sun card in it doesn't have this problem... The following is h/ware config .. juno# /usr/platform/`arch -k`/sbin/prtdiag System Configuration: Sun Microsystems sun4u Sun Ultra 2 UPA/SBus (UltraSPARC-II 296MHz) System clock frequency: 99 MHz Memory size: 256 Megabytes ========================= CPUs ========================= Run Ecache CPU CPU Brd CPU Module MHz MB Impl. Mask --- no keys------ ---- 0 0 0 296 2.0 US-II 2.0 ========================= IO Cards ========================= Bus Freq Brd Type MHz Slot Name Model no keysno keys--------------------- 0 SBus 25 2 cgthree Integrix,S20V 0 SBus 25 14 SUNW,fas/sd (block) 0 SBus 25 14 SUNW,hme 0 SBus 25 14 SUNW,bpp No failures found in System