Use TEW-639 as a Wireless Access Point and Switch

July 6, 2012 at 12:45:16
Specs: Windows XP
Here is my set up: is a Linksys WRT610N acting as a router and DHCP server for addresses .100 to .150 is TEW-639 with DHCP turned off and connected to the Lynksys via one of the LAN ports.
I then have a FosCam camera with IP, connected either wirelessly or via a wire on a LAN port to the TEW-639W.

Here is my problem:
If the FosCam is connected wirelessly to the TEW-639W I am unable to see it from any device connected to the Linksys. If I connect the FosCam via a wire to a LAN port on the TEW-639W then I can see it from a device connected to the Linksys device.

If a device is connected to the network via the TEW-639, I can see the FosCam whether it is hardwired or wirelessly connected to the TEW-639. What am I doing wrong?

Why can I not see the wireless connections on the TEW-639 from a Linksys connected device?

Thanks in advance for any help you can give me!


PS: The setup is that the internet comes in and is connected to the Linksys, which then via LAN cable and LAN ports on both devices is connected to the TEW-639, which is then connected to the camera
Diagram of Setup

See More: Use TEW-639 as a Wireless Access Point and Switch

Report •

July 6, 2012 at 13:26:04
check in the tew that you do not have the guest network engaged and that is what you are connecting to.

also some routers have a checkbox to "bridge" the wifi and lan. if this feature exists it needs to be checked so lan can see devices on the wifi and visa versa

Answers are only as good as the information you provide.
How to properly post a question:
Sorry no tech support via PM's

Report •

July 6, 2012 at 14:53:59
There is no bridge mode, but I agree that seems like the problem.
What do u mean by guest network engaged

Report •

Related Solutions

Ask Question