Does EIGRP work on sub-interfaces?

compaq / Desktop en
September 11, 2010 at 12:54:19
Specs: Windows XP, 512
IF yes.What commands do i have to enter into the router to allow load balancing of 2 eqaul links between 2 adjacent routers?

See More: Does EIGRP work on sub-interfaces?

Report •

September 11, 2010 at 22:31:41
What is the make/model of Router ?? and have you read the manual ??

Report •

September 12, 2010 at 05:29:35
I'm guessing you mean more than one router. As X86 pointed out, make/model of them would be very helpful. If you're talking about Cisco equipment, go to Cisco's website and start searching for a command reference for the router(s) you have. They're actually pretty good about publishing this type of information.

It matters not how straight the gate,
How charged with punishments the scroll,
I am the master of my fate;
I am the captain of my soul.

***William Henley***

Report •

September 12, 2010 at 11:28:15
Thanx for replying.Maybe i did n't put my question correctly.I want to do load balancing on 2 equal links to the same destination and between cisco routers.The challange i am facing is when i configure eigrp between these routers it is running fine but not load balancing.These links are configured on sub-interfaces of the same g0/1.1 and g0/1.2.So will loadbalancing work on sub-interfaces of the same interface.if yes which commands can i use ? Thanx in advance

Report •

Related Solutions

Ask Question