Configuring two NIC's on one PC using MS DOS

September 30, 2009 at 22:20:02
Specs: MS DOS 6.22
Hi Champs !!
I need your help to configure two NIC's in one PC using MS DOS 6.22. Is it possible if yes kindly guide.As i want to connect it to two diffrent networks.

See More: Configuring two NICs on one PC using MS DOS

Report •

September 30, 2009 at 22:31:24
Dos has no networking natively.

You have to install msdos client 3.0

here is a link that appears to still be good [this stuff is very old]

don't know about multiple nics. those didn't exist in those days due to expense. instead we bound multiple clients/protocols to one nic. Should be possible since you have to name the card to bind to it

Report •

September 30, 2009 at 23:19:40
What software and networking protocol are you using ?

If you use WATTCP with Packet Drivers then yes two NIC's are entirely feasible............

Though it is what else is on the network that may be the deciding factor.................

Report •

October 1, 2009 at 17:22:01
If you have network adapters then you can usually go to the OEM's web site and get the software needed to config the card and add support.

To make it simple you could get Bart's Network Boot Disk.

Playing to the angels
Les Paul (1915-2009)

Report •

Related Solutions

Ask Question