Subject: SFT-3 installation problem System Configuration IBM x-series 220 server Pentium III 800 MHz , 256 MB SD SIMM 128 x 2 9.1 GB x2 Ultra wide scsi HDD, ADPT160M Controller for HDD ide cdrom , On baord network adapter PCI MSL Card DECMSL4x.msl I am faceing problem to config SFT-3 After installing stand lone server properly, transforred data from old server to new server Reboot server 2 /3 time, server mount properly and also connect with client computer through remote boot. After this convert server to SFT3 and create three floppies, load msl driver, it showed wait for second machine Shifted to secondary server run install through first floppy insert second and third floppy asked msl driver know both server is connected throuth msl card. Load hdd, lan and msl driver at both console and ip route is up. create msauto.ncf, msstart, ioauto, iostart down the server run mserver at both server activate server at primary server it ask msengine name and ipx internal no. after type name and no. It doesnot load hdd controller driver and not connect to secondary server when load manualy hdd and lan driver it load . But it not mount vol sys and also not mount any volume and give error message : "Definition for syne 0 of volume sys removed. server 4.11-208 definition for volume sys is invalid server 4.11-1649 volume sys could not be mounted some or all volume segment connot be loaded." (I create dos and netware partition same to same ) dos size 200 MB, sys 1000 MB, 2000 MB vol1,vol2,vol3, all free space vol4 When run server.exe command at primary server it works properly and mount sys and all volume and also connect client PC. Please advise me what's the problem. Waiting for your reply. With regards, Jatinder Singh jatinderbajwa@yahoo.com

msl.txt file would be there in the msl card floppy - check it it and read that readme.txt exact proceedure would be there how to install sft 3- bcas driver are based depending on card - or you can also take readme.txt file printout .let me know