When I first upgraded my server to netware 6, i had navce 7.6 running perfectly. I have since had to rework my server and now the NAV will not run. I am figuring that there was an update to NAV allowing to run, but am not sure. I am looking for any possible assistance with this issue. Thanks

You gotta help us out a bit here man. What do you mean by "NAV will not run"?: You're trying to start it at the server and it dies or what? You're thinking maybe that NAV was patched and now you don't have the patch? You cut off NAV's legs? What did you do when you reworked your server?

NAV will start on the server, but after a few minutes or so, it causes the server to abend. I had to completely reinstall the server when I added a new SCSI controller. The system is running on SCSI HD's so the existing controller was the primary controller in the system. In changing it, the system would not boot, forcing the reinstall. My thought is that there is a patch for NAV out there but I cannot find it. I saw a KB article either on Novell's site or Symantec's site talking about this issue, but I can't remember which one it is. Sorry about not giving all this info to begin with, guess I should have.

Ok, that makes more sense. So, you need the patch for NAV I guess. I can't find it on the Norton site or on any searches. I'd say your best bet is to email Norton directly. Regarding reinstalling the server, you probably didn't really have to do that. If it was a SCSI driver issue in Netware, it could have been resolved without a reinstall. A boot issue can normally be resolved by starting with a bootdisk and accessing the netware FAT partition. There's not many (if any) situations where you would have to reinstall Netware to fix a problem. Just a heads up for next time.

Thanks for your help. I appreciate the input as well about the HD thing too!

Good luck Brian.