I'm not all that familiar with Novell. I have a Netware 5.0 server that I need to statically address, could someone help with the commands

at the NetWare command prompt: INETCFG From the Internetworking Configuration menu - select Protocols From the Protocol Configuration menu - select TCP/IP TCP/IP Protocol Configuration menu: Set the TCP/IP Statue to Enabled Set the IP Packet Forwarding to Disabled ("End Node") Set LAN Static Routing to Enabled In the LAN Static Routing Table - enter on it, then select Insert key - set up a Default Route and set the Next Hop Router on Route to your network router - ESC to backout and save ESC out of the TCP/IP Protocol Configuration menu and save changes if prompted ESC out of the Protocol Configuration menu From the Internetworking Configuration menu select Bindings From the Protocol to Interface/Group Bindings menu select the Insert key and select TCP/IP from the menu of available choices If prompted to Bind To? Select A Network Inferface Select the appropriate network interface (your list of NICs in the server will be listed) From the Binding TCP/IP to a LAN Interface menu: Set the Local IP Address to, whatever IP address you need to set it to. Set the Subnetwork Mask of Connected Network to, whatever you need, typically 255.255.255.0 ESC out and save the changes and exit the Internetworking Configuration menu type in REINITIALIZE SYSTEM at the server prompt.