Hi,

I have a Linksys WRT54GX router and I can connect and get ok signal being close to the router, or outside, but if I go 100 yds in the house, it immediately drops in signal strength from excellent or good, straight to very low then loose connection, then it will have trouble re-connecting.
I've been on the phone with AppleCare and Linksys Support, did an upgrade on the firmware, tried some different settings, I am currently using WPA, and to no avail. I've also tried a Belkin N1 and was on support with them too, and still the same problem. My system also has the built in Airport as well. Everything is came loaded as discribed below.

Are there any drivers, fixes, recommended settings, wireless boosters, something that can assist me with increasing my range and connectivity, speed would be a blessing too. Really thought switching to Mac from PC would be a great thing, thus far only one problem after another. Very disappointed so far...

Here are my specs:
2 mo. old MBP
Mac OSX – Leopard 10.5.1

Processor: 2.2GHZ Intel Core 2 Duo

Memory 4GB 667MHZ DD R2 SDRAM

L2 Cache: 4MB

Bus Speed: 800MHZ

Boot ROM Version: MBP 31.0070B02

SMC Version: 1.16F8

Serial #: W87383ZSYAL

Sudden Motion Sensor: State: Enabled

NTFS-Parition 93.12GB for Windows

ATA Bus: HL-DT-ST DVDRW GSA-SLON

Audio (Built in) Device ID# 0X106B00A0

Firewire Bus: Max Speed: Up to 800mb/sec

Graphics/Display: GeForce 8600MGT

Vendor: NVIDIA (0x10de)

Device ID: 0x0407: Revision ID: 0x00a1

Rom Version: 3175

Parallel SCSI: states: doesn’t contain

BootCampAsst: 2.0

Parallels Desktop: 3.0 Build 5160.0

Any advice, recommendations would be tremendously appreciated.

Thank you,

Kitti