Computing.Net > Forums > Linux > linux installation problem

linux installation problem

Reply to Message Icon

Original Message
Name: murtaza
Date: May 13, 2003 at 21:19:06 Pacific
Subject: linux installation problem
OS: linux 7.2
CPU/Ram: AMD k6 450MHz / 64MB
Comment:

i have tried many times installing linux in my AMD K6 / 450 MHz , 64 MB ram computer. Almost all the times after doing 50 - 60 % installation error message comes "Installation exited abnormally Sending termination signals ....... "

Once i was able to install linux 7.1 sucessfully with minimum configuration without GUI that too after n no. of trials. But when i tried to upgrade it for installing other packages then unfortunately filesystem get corrupted and then i tried to reinstall but now it is not getting installed.

is this the error in my processor or something else. i have installed with the same CD in P3 and it was installed successfully.

please respond urgently


thanks

murtaza


Report Offensive Message For Removal


Response Number 1
Name: Deputy DooDah
Date: May 13, 2003 at 21:33:51 Pacific
Subject: linux installation problem
Reply: (edit)

I have a K6-500 running Redhat 8.0, so I don't think it's your processor.

That is a tiny amount of RAM though. I'm not sure how much a typical Linux install process uses. Anyone?


Report Offensive Follow Up For Removal

Response Number 2
Name: Bobthearch
Date: May 13, 2003 at 21:44:04 Pacific
Subject: linux installation problem
Reply: (edit)

Deputy DooDah,

Depends on the distro and software. My Mandrake box says 32MB required, 64 MB recommended. Peanut Linux can run on a very minimal system.

~~~~~~~~~~~~~~~~~~~

murtaza,

Hard to say what the problem is, but I doubt it's too little RAM. Could it be that the partition isn't large enough for the amount of software being installed?

-Bob


Report Offensive Follow Up For Removal

Response Number 3
Name: 3Dave
Date: May 15, 2003 at 03:10:55 Pacific
Subject: linux installation problem
Reply: (edit)

If the partition is not big enough, setup
would probably warn you. Have you tried
running a low level format on the hard
drive. Perhaps it is corrupted somewhere.
Try repartitioning it but make a note of the
heads/cylinders/sectors of the hard drive
and pass on those settings to both your bios
and fdisk (or whatever linux partitioning
program that you are using).


Report Offensive Follow Up For Removal

Response Number 4
Name: murtuza
Date: May 17, 2003 at 01:50:03 Pacific
Subject: linux installation problem
Reply: (edit)

i m havig approx 4 GB for linux partition and i have increased RAM also by 128 MB. My total RAM now is 192 MB. Even then it is giving same error.

can u please tell me what is low level format.


thanks

murtuza


Report Offensive Follow Up For Removal

Response Number 5
Name: 3Dave
Date: May 20, 2003 at 05:55:06 Pacific
Subject: linux installation problem
Reply: (edit)

A low level format may be available in your
BIOS....alternatively, the hard drive vendor
may provide such a tool from their webite.

After a low level format, you will need to
partition it and then do a normal format to
set up a file system.


Report Offensive Follow Up For Removal







Use following form to reply to current message:

   Name: From My Computing.Net Settings
 E-Mail: From My Computing.Net Settings

Subject: linux installation problem

Comments:

 


  Homepage URL (*): 
Homepage Title (*): 
         Image URL: 
 
Data Recovery Software




How often do you use Computing.Net?

Every Day
Once a Week
Once a Month
This Is My First Time!


View Results

Poll Finishes In 3 Days.
Discuss in The Lounge