Computer Problems? Computing.Net has over 1,000,000 posts about all things technology related! Over 90% answered within 24 hours! Click here to start participating now! Also, be sure to check out the New User Guide.
Linksys WPC11 Wireless
Name: Greg Date: September 5, 2002 at 08:59:28 Pacific OS: Redhat 7.3 CPU/Ram: 500mhz / 192mb
Comment:
Hi all,
I'm trying to install a Linksys WPC11 pcmcia card onto my Redhat 7.3 Laptop. I have installed the kernel source at /usr/src/linux-2.4.
It is asking me for the following:
pcmcia-cs source dir [/usr/src/pcmcia-cs-3.1.22]:
I included the pcmcia-cs on the install, but I cannot find it. Does somebody know where this is?
Name: jason Date: September 7, 2002 at 19:52:58 Pacific
Reply:
i just put the card into my mandrake 8.2 laptop and it just worked there was nothing to do at all
0
Response Number 2
Name: Aaron Date: September 13, 2002 at 17:18:17 Pacific
Reply:
Hi Greg,
I have a WPC11 running 7.3. If you haven't resolved this prob. contact me and ill point you in the right direction.
Aaron.
0
Response Number 3
Name: Troy Perkins Date: September 23, 2002 at 21:52:13 Pacific
Reply:
Aaron - saw your posting on computing Net in regards to redhat 7.3 and pcmcia linksys wpc11.
I compiled /usr/src/redhat/SOURCES/ "pcmcia-cs-3.1.27" and "wireless-tools23" and installed them fine.. I then compiled and installed "linux-wlan-ng-0.1.14"
before an init pcmcia restart my card had a red solid light and flashing green and an ifconfig showed an eth0.
I did the init pcmcia restart and now I only have a red light. no green.
Summary: Can't get my Linksys WPC11 wireless pc card working in mandrake 9.1. I have Orinoco module loaded and wireless support. PCMCIA recognizes that a card is in slot 0. It thinks it is a realtek card. Any ...
Summary: hello, i am new to linux so i am not very good at all this yet. i have a laptop computer with a linksys WPC11 wireless card and i cant get the card to work. when i had mandrake i just put in the card...
Summary: Can't get my Linksys WPC11 wireless pc card working in mandrake 9.1. I have Orinoco module loaded and wireless support. PCMCIA recognizes that a card is in slot 0. It thinks it is a realtek card. Any ...
0 
installation of Lindows S...
