|I need to know if this is possible. I have an eMachines LCD screen. My Toshiba LCD on my laptop just broke (It didn't just break, it "fell". But that doesn't matter). I was able to connect it (Without any mods to the LCD!), and need to know something: The first time I rewired it, I used a lower gauge wire and the LCD started to flicker after a while. So, that being said, I rewired it again. Will the monitor work with the correct gauge as supplied with the LCD? My laptop's original CCFL lamp cables were high voltage wires. These are thin (almost look like RJ11 style wires (on the inside)) wires, but it still connects. I turned it on, and it works. That's what happened last time. But that time it flickered a bit too. This time, I didn't test it as long. What will happen? Oh, and last time (with the higher gauge wires), the inverter would get pretty hot, but this time, it doesn't. And for anyone who asks, it did get hot as soon as the PC started. However, with the rewire, it doesn't. My base question: WILL IT WORK OR NOT????? I don't want to lose my LCD screen. Although I have another one...|
If God is phone, then who is door?