I have two printers and a scanner. The main printer is attached to the parallel port (LPT1, IRQ 5) of my Micron Pentium II. To accomodate the other printer (which must be on IRQ7) I installed a SIIG Cyber Parallel Dual PCI Board. Getting the PCI Port on IRQ 7 has always been a challenge whenever I had to reinstall OS, etc. I did have the following configuration set up and functioning successfully for two + years: Ports - COM 4 and 5 Cyber [LPT2] Printer [LPT1] SIIG Cyber Parallel PCI Board - IRQ7 i/o 0378 - 037F i/o 0778 - 077B but then had to reinstall Windows98 and now the settings are a mess: Ports - COM 2 and 4 Cyber Parallel PCI Cyber Parallel PCI Printer [LPT1] SIIG Cyber Parallel Dual PCI Board - IRQ7 i/o 1010 - 1017 i/o 1040 - 1043 i/o 1018 - 101F i/o 1044 - 1047 When I try to change the settings of the SIIG Cyber Parallel Dual PCI Board, I get: This resource setting cannot be modified. How do I get LPT2? How can I change the i/o settings of the PCI Parallel? TIA, Frank