PC won't boot up;no signal to monitor/keybrd

November 26, 2010 at 11:51:23
Specs: Windows XP
2005 Gateway Media Center PC
Windows XP
Intel Pentium D processor 820
Model GT5018E
1024 MB DDR2

have quadruple checked all connections, shut down many times trying to restart; sometimes can here fans go on, but don't hear the processor kick in.

tried putting in recovery disk

tried removing and reinstalling battery

See More: PC wont boot up;no signal to monitor/keybrd

Report •

November 26, 2010 at 12:22:34
You NEVER try re-installing Windows or the original brand name software when the computer itself is not working properly !

If this is a desktop computer.....

Failing power supplies are common and can cause your symptoms.
Check your PS.
They often partially work, fans and hard drives may spin, leds may come on, yet you may get no video and the mboard will not boot all the way.
See response 4 in this:

If it is failing, you can usually replace it with any decent standard sized standard ATX PS with the same capacity or greater.

Standard (PS/2) power supply size - 86mm high, 150mm wide, 140mm deep, or 3 3/8" h x 5 7/8" w x 5 1/2" d , or very close to that, though the depth can be more or less for some PSs.

Don't buy an el-cheapo PS.
See response 3 in this:

Your power supply must have at least the minimum capacity required to support a system with the graphics card you are using installed, or the max graphics card you might install in the future.
(Onboard video - video built into the mboard - IS NOT A CARD ! )
If that info is not in the ad for the video card, you can go to the video card maker's web site and look up the specs for the model - often under system requirements - the minimum PS wattage, and, more important, the minimum amperage the PS must supply at 12v is stated. If you don't find that, any card with the same video chipset including any letters after the model number has very similar minimum PS requirements. Some power supplies have two or more +12v ratings - in that case, add those ratings to determine the total +12v current capacity.

If you're a gamer...
In most if not all cases, the max capacity rating of the PS is an intermittent rating. It's recommended that you do not load your PS to any more that 80% of that rating if you are going to be using something that puts a constant load on it, such as playing a recent game for hours on end. In that case, you multiply the min capacity stated for the system with the particular video chipset on the card by 1.25 to find the min. capacity of the PS you should get.

Report •
Related Solutions

Ask Question