nVidia GeForce3 Ti200 video card display problem

Home / HOME
September 2, 2013 at 08:05:52
Specs: Windows xp, 3.0 512
I have installed windows XP ,video card card is GE FORCE ti200 after boot up few seconds after no signal only to way display when it is on safe mode. drivers are ok..Adaptro information shows unavailable. I did some changes in BIOS but did not work .
How can I fix this issue.

See More: nVidia GeForce3 Ti200 video card display problem

Report •

September 2, 2013 at 14:41:55
Try different drivers or try a different slot.

How do you know when a politician is lying? His mouth is moving.

Report •

September 2, 2013 at 16:20:32
no it doesn't work.

Report •

September 2, 2013 at 16:37:00
So you get a display in safe mode but not normal mode and no problems show with the drivers in device manager?

In safe mode open display properties and set the resolution to 800 x 600. If there's an option to change the horizontal frequency there then set it to 'adapter default'. Save settings, exit and reboot to normal mode. Assuming you get to the desktop then from there you can open display properties again and set them to something your monitor can handle.

Report •

Related Solutions

September 3, 2013 at 05:54:21
"I did some changes in BIOS but did not work"

Why did you mess with the BIOS & what did you change?

The Ti200 is an old card & seeing as how you only have 512MB RAM, you probably have a fairly old system. 512MB is barely enough to run XP, 1GB should be considered the minimum for reasonably good performance.

Make sure you've installed the motherboard chipset drivers 1st, then install the graphics drivers. Here's the graphics driver you should be using:


Report •

Ask Question