When you said you pulled everything off the MB did you disconnect the data and power cables to the drives? Try reseating the video card and Ram. Only use i stick of ram in stripped down mode. If you have more than 1 stick of ram, try the other one if no go. Clear that CMOS using the onboard jumper. Have the machine unplugged while performing this operation. Pulling out the battery is a iffy way to clear the cmos. Also, make sure that the jumper is returned to the run position before you startup. Usual run position is pins 1&2 and clear 2&3 but you should check your manual. If you don't have a manual, download one. Don't have the MB specs, use aida32 to get specs. Download aida at: www.aida.hu If you pulled the MB battery out, make sure it is installed right. Make sure the monitor is connected and turned on.

0

ok heres the list of what Ive done Pulled everyhing off put different ram in new video card changed cmos battery reset the bios pulled battery out took out cpu put it bacj in took out all cards tried different monitors still nothing!!!!!! And everything seems to be running fine except theres no signal from the pc to the monitor.My monitor comes on it turns on and then I get nothing.I turn the pc and the monitor goes off.?? Is it the agp slot?? should i invest the 60 bucks for a pci video card but if it dont work Im stuck with it. anyone have any idea's

0

Do you have a generic old PCI video card, a 4 meg pull perhaps, give that a try. If you dont have one let me know Ill send one to ya, I litterly have dozens from old computer that I have striped and sold the mobo/cpu's from.

0