Ok I've purchased some ram - 2 * 1GB PC 3200, DDR DIMM, 400Mhz I purchased it for a Dell Dimension 1100 / B110, According to the manual My computer is capable of taking This ram yet When I attempt to install it the ram is not recognised and the computer will not start, It'll give the a Diagnostic light error that basically says something's wrong with the Ram. I've checked my Bios and it's up to date I believe, I cannot contact DELL tech support without the requirement of sitting on the phone for 3 hours till they get me off hold -.-. ANY help or advice is appreciated, I'm doubtful that the RAM is faulty, This is the second Batch of Ram I have purchased that would not work.

Also The Ram is "Non-ECC" - The link to what I bought - http://cgi.ebay.com.au/ws/eBayISAPI...

the ebay listing says the ram is HIGH DENSITY, some PCs have problems with that. How many chips on each memory stick. For example, some PCS will take a certain size memory stick if it spread over 16 chips on the stick, but not 8. Because the chips on the 8 chip stick are too 'dense'.

Thanks, That was the problem, Excuse me while I go cut myself for blowing 80 bucks >.>

Yeah stay away from high density 4 layer PCB ram, it is cheap for a reason. I buy from www.digi4me.com