I just bought a new case of Ebay, i've attached pic of it, its a X-Blade Extreme with LCD panel. Problem i have is the front panel connectors for the USB and Audio do not match the motherboard. I have a Asus A7V333 board, it supports front panel cases, but the wording is different. In my Motherboard Manual it says: BLINE_OUT_L, Line out_L, NC, BLINE_OUT_R, Line out_R, +5VA, MICPWR, AGND, MIC2. Where as on the wires it says: L IN, L Out, R IN, R Out, 2 GND's and 2 Mic in's where do they plug into on my board? Also i dunno the USB either my shows: NC, 2 GND's, LDP1, LDP2, LDM1, LDM2, 2 USB +5V. And the wires say GND 1, Data-1, Data+1, Vcc 1, GND 2, Data-2, Data+2, Vcc 2. Now with that i think i sorta have an idea, that LDP1 = Data, but dunno whether it - or +, and VCCc i don't have a clue. And where do i put the temperature sensors, do the hardware have specific spots for them, or do i just attach them to any part of the hardware? And last thing, the 2pin connecter from the LCD does that connect to the cpu fan connecter, which usually plugs into the board? Any help be grateful thanx Chris

Hi heres a clear set of pics to set up the usb header http://www.overclockers.com/articles865/index02.asp remember to sort the wires out , each usb has 4 , and will be labeled in sets to connect to mobo board header to case pannel so yours are vcc1 -connects to (5volt usb5+v), Ldp1 -(DATA1), Ldp2 -(Data2), gnd-GND1 other set of usb headers match up to corresponding pin headers regards

Ok i got the usb working now, but audio still no go