emachine recovery manager comes up, only let me choose exit

February 26, 2012 at 14:45:03
Specs: Windows 7
got new recovery disk set from emachine i have followed the paper that came with them and i can get the emachine recovery manager to come up but it only let me choose exit and wont read the other disks

See More: emachine recovery manager comes up, only let me choose exit

Report •

February 26, 2012 at 21:08:39
If the original hard drive was not damaged then you should be able to restore to factory restore from your recovery partition that is already on the hard drive, just see your online manual for details.
If you are actually booting the the recovery disk set (Set the DVD drive to first on boot order in BIOS, then 'hit any key to boot to CD/DVD', etc.) and it cannot proceed then you have a bad recovery disk set. If you are trying to launch the recovery disk from within Windows, then you are doing it wrong.

You have to be a little bit crazy to keep you from going insane.

Report •

February 27, 2012 at 10:07:50
Are you trying to load the Recovery disk set on the original hard drive, or on a different used hard drive, or on a new hard drive ?

If you're trying to load it on the orginal hard drive, or another used hard drive, the hard drive may be in the process of failing and that may be the reason the Recovery disk set refuses to install.

Check your hard drive with the manufacturer's diagnostics.
See the latter part of response 1 in this:

If you don't have a floppy drive, you can get a CD image diagnostic utility from most hard drive manufacturer's web sites, but obviously you would need to make a burned CD, preferably a CD-R for best compatibility, on another computer if you need to.

Seagate's Seatools will test (almost) any brand of hard drive.
Do the long test.

The bootable Dos versions of SeaTools can be used even if Windows is not working properly.

If the hard drive itself tests okay, any data problems found can be fixed, one way or another.

The Recovery disk set must be the correct one, otherwise it will refuse to load on your emachines model.
(If you have changed which mboard your desktop computer has, the Recovery disk set will probably refuse to load on your emachines model, unless it's the same mboard model that has an emachines bios version.)

If you used your emachines Serial number to order the right one here:

Accessory store - Purchase Accessories, eRecovery CD's....

, it should be the correct set.

Check there to see if the listed set matches the one they sent you.

If they sent you the wrong set, or if they sent the right set but you ca't get it to work, contact emachines if you need to

NOTE that the set must be for the same version of the operating system that your model came with, that's shown on the official Microsoft label that's stuck to the outside of the computer case.

Report •

March 20, 2012 at 23:54:35
Hello, l greatly suggest you try to use the free data recovery software which is the most efficient recovery software .
A step-to-step user guide is below: First, download Photo Recovery. And install it someplace other than the disk that you want to rescue deleted photos. Second, launch it, select the disk you want to rescue in left list and click "Next" to start the automatic scanning process. Third, choose the ones you want to recover from the list of all recoverable photos and click "Next". Fourth, Select a folder to store the recovered photos. Click "Next" and the photos would be rescued successfully. I feel that finding old photos is to find some valuable memories. That's significant thing. I wish you good luck.

Report •

Related Solutions

Ask Question