Hi, Had trouble with one these lately. http://www1.ap.dell.com/content/products/productdetails.aspx/pwcnt_2708_th?c=th&l=en&s=lca I this is a switch not a router correct than runs at gigabit speeds, right. I tried to get into it via it's instruction manual by the old browser way. 192.168.0.2 I think is what it was. I know it was the right address as it was the one on the site, in the manual and in the quick install pamphlet. Ok so that didn't work so I tried various ones from linksys, dlink, etc... nothing. It also had a managed and unmanaged button, which you had to press with a pin. I believe that had to on so you acccess the box, but that did not work either. Would this switch have supported NAT, and had any thing like SPI? Cause I sent it back as it was far too expensive for what was needed. A coughed up for a linksys router befsx41 that was only 10/100 but suffice. The whole reason was to make a two box lan from tcp/ip and wan connection. The box has eight ports starting at one which I plugged the wan line into. And box got port 2 and box two got box three. Which was great for internet connection. Would not work for lan as the addresses where not a private ip address. I even just tried using the windows lan maker or whatever it is called. Nothing. What was wrong aside from the obvious dell switch not allowing configuration.