computer recognises internal drive off & on

July 4, 2011 at 08:23:57
Specs: Windows 7, pedium4 3G/ 1,5G
computer recognises internal drive off & on
i cant install
please help me

See More: computer recognises internal drive off & on

Report •

July 4, 2011 at 08:34:55
What is the make and model of the brand name computer, or if you have a generic desktop computer, what is the make and model of the motherboard ?

Was this same computer working fine previously ?

If yes, have you just made any changes to it , or have you been fiddling around with anything inside the case if it's a desktop computer, wiring connections or components, before your present situation ?

Did you have any symptoms of something being wrong for a short time, or for a while, before this present situation ?
If so, describe them, in as much detail as you can come up with.

If this is a desktop computer....

It is common to un-intentionally damage IDE data cables, especially while removing them - the 80 wire ones are more likely to be damaged. What usually happens is the cable is ripped at either edge and the wires there are either damaged or severed, often right at a connector or under it's cable clamp there, where it's hard to see - if a wire is severed but it's ends are touching, the connection is intermittent, rather than being reliable.
Another common thing is for the data cable to be separated from the connector contacts a bit after you have removed a cable - there should be no gap between the data cable and the connector - if there is press the cable against the connector to eliminate the gap.
80 wire data cables are also easily damaged at either edge if the cable is sharply creased at a fold in the cable.

Try another data cable if in doubt.

80 wire data cables must have the proper end connector connected to the mboard IDE header - usually that's blue, but in any case it's the one farther from the middle connector on a 3 connector data cable.

Check your SATA data cables. The connector on each end should "latch" into the socket on the drive and on the mboard, or on the drive controller card - it should not move when you merely brush your hand against it near the socket - if it does, mere vibration can cause a poor connection of it - use another SATA data cable that does "latch", or tape the connector in place.
(There is a slight projection or bump on one side of the outside of the connector that "latches" it into the socket - it's easily broken off or damaged)

The same thing applies for the SATA power connection.

Report •
Related Solutions

Ask Question